Search results

Do yourself a favor and use so cord or extention cords. Romex is a bitch to roll up Sent from my SM-G973U using Tapatalk

4 is a bit overkill, but it wont harm anything in your setup if you ground the generator make sure the neutral and ground are bonded together at the generator and only at the generator. Sent from my SM-G973U using Tapatalk

How about corner grounded delta? Sent from my SM-G973U using Tapatalk

more accurately 120 degrees out of phase vs 180 degrees out of phase Sent from my SM-G973U using Tapatalk

yes. 120 single, 120/240 single or 120/208 three

What mode do you have it set in?

They should be, usually on these sets the 120/ 240 setting is double delta and not a low open or closed delta

Thats when you have an open or closed delta winding. line to line will be 240 all around (L1-L2, L2-L3, L3-L1) and line to ground on L1 and L3 will be 120 L2 to ground will be 208. which is your high leg or wild leg. Wild leg is more commonly used with an open delta configuration as it tends...

Do You have the engine up to speed (60 HZ) where are you measuring voltage?

Spark air or fuel, I had a gas generator do something similar, ended up being a bad coil

Oh thats a shame. Hopefully You and yours fared well. Steel part or Aluminum?

The advantage is in the ratings and the availability. Do yourself a favor and install a battery disconnect switch as well.

If you are not connecting this to an established service, bond the neutral to ground and drive a ground rod Sent from my SM-G973U using Tapatalk

I really need to stop reading these posts on my phone.

My 003 with 3 of the 4 bad didnt vibrate too bad. the spacer is rubber coated .

until all #17s delaminate, and all #19s fall upon all #20s then it looks alrght, just 9/16 inch shorter

maybe this will help

Yep, Many ways to fix this.

Measured at .8765 inch. The spacer is longer but the motor mounts are conical in the inside, so the bushing is much shorter than the spacer. OD dimensions of the spacer may vary as it is coated in rubber.

It can work, the only problem that my have is getting the spacer pressed into the tubing. at 7/8 inch the spacer was still a tight fit. More than one way to defur this particular feline.