Search results

Okay looked at the vent lines from the axle, both were completely blocked. Enough that when pulling the fill plugs, both rear axles let out a fairly significant hiss. Truck hasn't been driven for a few days.

Wondering if anyone can describe what's in Eaton PN 599913 rebuild kit?

Thanks for the info, I looked at the vent lines but didn't have time to follow their routing as it went up the frame rail to somewhere, so many lines there it will take a bit to trace.

That pepper trick saved my ass on an old landcruiser :)

Noticed a rear tire was down on pressure a bit so refilled to 80psi. Also replaced the quick release valve near the muffler as it was missing. Then after a drive, gear oil sprayed out of the discharge from the quick release valve on the forward rear axle(connected to the tire that was low)...

My truck came with 3d printed handles, broke the third time I used it. Truck latches also needed lube so there was extra stress. I replaced them with aluminum ones and lubed latches. I wouldn't use 3d printed parts for this situation. Considering potential high loads, it's not their ideal use...

Wind was pushing them back, had to have my kids constantly fix them. Looked around the hose and found some scraps that I mounted with the unused screw holes on the doors. Clamps are just standard cable guides (silicone) and the other parts are aluminum pieces I had laying around from other...

Is the coolant recirculating in this overflow? With gas engine overflows it doesn't.

It has the bayonet plug on the top of it, also has the multiple battery shut off points (physical one beside the battery box, switch driver side kick panel, switch right side of engine bay)

Seems this had to be a modification? Wiring diagram for A1R I don't see mention of a 100amp option, only the 260. It has all the other A1R stuff (grab handles, insulation, WTEC IV, etc).

Thank you! Still new to how to use the TMs.

M1096 MTV, but should be the same for any of the MTVs I would think.

Totally agree, although with CTIS that introduces air exchange.

Can't find anything on here of the TMs about this (only the part breakdown) Seems to have a fill plug so I'm guessing oil filled till comes out the hole? Any other ideas?

That introduces the variable of evaporation of the water though.

I was looking into this a bit, ethelyene glycol is not a great choice as it's freezing point is relatively high (would freeze in my WI weather ). Propylene glycol has a much lower freeze point. Also it's non toxic.

Ahha! Now the other references about PPE, skull thickness make sense :LOL:. Glad he is okay though, squashed grape is no good. :)

I think I'm missing an inside joke.

Any update on a source for new bushings? Mine are pretty much gone.

So I bought the truck and had some really strange wires going to the taillights, one for right turn, one for reverse. See the wire and black wires here: (also notice the black wire seems to be holding the trans cooler line :oops: The blue circle is where the trans line was rubbing on the bolt...