Search results

That's where I bought mine, good price and quick shipping.

Perhaps they had a piece of glass that was close and used the tin as a spacer. You can use a single piece of glass and a new gasket, just take it to a glass stor and have it made. Otherwise you will need the spacer and two pieces of glass to make it original.

The M151/M151A1 had a two piece windshield with 2 vacuum wiper motors, the A2 had a one piece with asingle electric wiper motor. All you need to convert them back and forth are the correct hinges.

I would like to know how you get an S-250 in a M101 cargo trailer without modifying it?

There was never any rails for the bedsides. The dunnage lifts the shelter off of the bed sides. All the S-250's are the same dimensions, just the interior layout, exterior panels etc are different. The only hardware in the bed is the front crossbar and the two rear brackets.

If the voltage is the same as "off" then it is not charging.

MIL–SPEC WIRE & CABLE Co. Web Store - Ham Radio Midwest Military Home Page you never know what this guy has stashed away, he buys alot of WWII Korea era stuff, worth a call.

No external voltage regulators, verify gen 1 is hooked up correctly. Sounds like gen 1 internal regulator may be bad. Try swapping generators and see if the light staying on problem follows the suspect gen.

It is an A2, look at the rear wheel well.

Looks like my brother and I will be there on Saturday for the day, probably carpooling down in a HMMWV this year.

From the pictures in the HMMWV TM it looks to me like the install kit for the S250 bolts to the floor of the truck not he shelter. I will post some pictures of mine sitting in the dunnage. Mine is built from 2x6 pressure treated lumber and decking screws, I did not paint it.

Any cucv will need the dunnage for the S-250, all the cucv pickup beds are identical in interior dimension. The M1028 has the tie down bracket kit installed from the factory, overload springs. The cucv dunnage plans work with all the cucv's and a S-250. You don't need the dual wheel...

All the S-250's are the same on the bottom, if you have a CUCV/M880 you will need the dunnage.

You need the shelter cribbing/dunnage, most people don't know about it. It keeps the shelter centered in the bed and off of the bed rails. All the tie downs do is keep it from tipping out of the truck. There are plans to make it for the various trucks in the supply bulletin SB 11-640. I built...

Aluminum body, M1031 cab/chasis should have the front locker. Not sure on the later as mine has the pto generator. Not all of the older maint bodies are on M1031 cab/chasis, check to make sure.

I have used many of those red cans, they are used for 2 stroke MkIII portable fire pumps.

I guess you could use it for fuel but I doubt you would ever find a spout for it.

If it is the original configuration the top hot post of the relay should show 24v off, 12v in the on position if the relay is energized and providing power to the glow plugs. The resistor bank is fed from the 24v block on the firewall behind the rear battery. Once power is applied to the...

I am not going but usually for the hams on the tactical FM radio's it's 51MHz and for 2meter 146.520.

The relay is located behind the diagnostic connector, remove the two screws holding it on and if I recall a third screw to the left of it, the starter relay(silver box)and two black relays will drop down on a bracket. I bought one of the new starters on ebay from db electrical and it lasted 3...