Search results

Just helping out with the knowledge I have about the truck. I do know that the two front tires are bad. The rears should be okay. Being 4x4, the transfer case can be put in neutral.

There are tow points under the bumper. Regular 1" pin feet fit just fine.

Well it always helps to go back to the manual. I just skimmed thru the TM 9-2910-226-34 Injector Pump Repair manual and on page 3-86 it explains how to reinstall the fuel rod. It even has pictures. ;-) http://www.steelsoldiers.com/upload/M35/TM9-2910-226-34.pdf Paragraph b says the lever...

I don't have a picture but when the fuel rod is removed you will see the plunger sleeve inside the hole. Using a small screwdriver see it it will slide up and down. You will probably need to use a mirror to see this. When installing the fuel rod, you see when the sleeve is and make sure the tip...

Here is Lavarok roof repair from a few years ago. I had a M1009 body I was hauling to the scraper and I cut out a replacement section and mailed to him. It fit nicely in a flat rate. http://www.steelsoldiers.com/showthread.php?69478-M1009-rusted-front-roof-corner

The cover looks complete. When installing the rod where you able to make sure the tip was seated in the groove of the plunger sleeve? If not the engine will not run correctly. When I did my first IP I had to reinstll the rod a couple of times before I got it right As a precaution, remove the...

There should be a clip on the rod lever Here is an old picture but it will give you an idea I cant tell from the first picture, Is there a small pin with a flat end insert in the hole in the lever?

If you want to be with us, meet at Reno and Sunnylane. We get to line up at the first on the parade.

A good read http://www.steelsoldiers.com/showthread.php?70846-Poll-Who-has-done-the-Doghead-Relay-Conversion

Moved question to its own thread

5 days away

Double check the diameter of the pulley. The stock pulley is 77mm and the most of the new ones are 66mm. Makes a big difference on which belt is needed. http://www.steelsoldiers.com/showthread.php?47479-Correct-Alternator-Pulley

I have seen very few (actually none) with the winch. Peashooters M109A3 in pictures is the only one.

Only items you own allowed to be posted.

Sure would help to know what truck you are working on.

Okay ladies and gentlemen. The big day is only 11 days a way. Looks like only 7 trucks will be there. Happyland make sure you wear your tie. It will look sharp. Also you can use it to wipe off the windshield if needed. M715VFD405 will be leading the pack in his M715. M813A1 fixed his fuel...

Welcome to the site. First order of business is that we reserve the "Help" in the title for 911 type emergencies when you are in trouble on the side of the road. Now to your issue. We need some background info on your skill set. Do you own a multimeter and know how to use it? Are you familiar...

I have found that smart phones aren't so smart. ;-) Some tasks are best done on proper equipment.

It is the nozzle and check valve for the Flame Heater. We have covered this many times. TM 9-2320-361-34P, Figure 31, Item #25 When ever I am stumped on a part, I open the parts manual, find the general area of the item and then find the picture of the specific item. That is what I just did...

You can put a pressure gauge in the port for the bleeder valve on the secondary filter.