Search results

must have been a USN m819

are the legs interchangeable, or is there a left rear, right rear, right front?

Where is Coleman's?

If it is, you could make a duct tape a bailing wire fix by... using the clamps that hold the heat shield on a deuce stack and a brace band (used in chain link fencing)

is the engine's exhaust stack the same size as an A2 deuce?

what, no flux capacitor?

RE: Frame-up restoration... er, unibody-up restoration d looks great! That before pic is one of my favorites.

you need to meet Matt in Live Oak FL.

I just deleted the smaller loop(the one between the pump and the block) to make installing the fuel supply line easier.

a lot roughly... 36k

do you have a flame heater?

how do the different types of filter conversions "seal" to the motor? I assume that the OD Iron setup uses the same gasket as stock since it uses modified cannisters. What about.... Jatonka's? Builder77's?

I was thinking it was just...tired

the wix/napa filters come with a gasket and an O-ring(both fit the base)... Which one should be used?

I would

somebody post a pic

mike do you have any wheels (m38a1) lying around?

used lights (traded other used "stuff" for them). I probably have only driven the truck 1000-1200 miles in the 18 months or so that I have had it.

I need to replace the driver's side for the third time :evil: (I have never had to replace the passenger side.) The wiring for the lights doesn't look as if it has been hacked and I replaced all the rubber isolators when I flipped the lights for the winch install. I am leaning heavily...

Gerhard, Do you know the specs on the pump? were there different versions etc?