Search results

My Donaldson cut the noise by more than half.... it sounds like a totally different truck.

I put new seals on my drivers side rear (that inner is a pain to get off). Whoever came up with the 3" PVC driver idea was a GENIUS... Cleaning the 90wt from the inside of an MRAP wheel without a water hose, in the dark was FUN. Wifey has already put away the garden hoses for winter... Just need...

I'd love a M1061A1, but its so HEAVY. Is there another flatbed that's not so "over built"? A more medium duty style (sorry i'm not current on trailers). To pull with a M35A2.

Sounds good, thanks.

I see the resistor in a pic above, on the firewall above the trans hump. Are the mounting clips screwed into the firewall or some sort of mounting board? (resistor mounting suggestions?)

I put her on the weight scales... 15,120 lbs. (full of fuel, empty, with my 200# in the seat)....

Thanks Rustystud. How much, or how far, do you think you were able to lower your pump? I'll have to put that on my "to do" list... ( I really should keep her above half a tank anyway)

Well, I thought i had some water in my fuel. So I parked it "nose down" on the passenger front for a couple of days. Then I pumped a quart or so from the bottom corner of the tank. It was all golden clean. But the truck would still stutter and almost die on me... So, I run up to the station and...

What would help with the slower starts? Timing or turned up fuel. My old engine started with just a bump, this one takes some pedal.

Welcome... from Granbury Tx.

Welcome... from Granbury.

I found out that safety wire SHOULD be used on the bridge holding the fuel rod in place... it only took about 40 miles to vibrate loose. Shut down handle had no effect. Had to stall it out in 5th to get it to shut down. Good Time..! There was no response to the gas pedal, RPM just went up and...

It has a nice clamp on it with about a 4" long bolt with 1/2" head and nut. It may sound dumb, but i was thinking of something like a fat rubber band over the air can housing end and under the mushroom tube, just to create some friction between the two parts...

Has anyone had any problem with their intake mushroom being loose....? I've tightened mine down till i think its about to crush the tube, only to notice it trying to lay on the fender. If it has happened to you, how did you fix it..?

OK, cool.... maybe its just a hiccup. I didnt try to restart it after it died. I think it just needs to run, it ran perfect and strong a couple of days ago.

My deuce died on me today... i was moving it back to its parking spot after doing some excavating with a backhoe, and it sputtered and almost died, then when i got it parked it did it again and died. I had put one fresh clean quart of ATF in the tank a few weeks ago ( to see what it would do for...

Can a clogged vent blow our that much lube....? (mine is leaking now, after a 30 mile drive...) Bur mine is on the inside of the wheel... (I ordered a full seal kit)

Last I talked with them was April 2012, (www.facebook.com/MVCNTX) I havent checked on them in a while but you can.

There was a group that gets together once a month in North Richland Hills...

Yep, i found one of my outside seals was on backwards too... it was pretty loose and dry....