Search results

PEX works much better.

I'll confirm that 1/2" PVC will NOT work. Back to Home Depot to get PEX...

Does that stop it from bouncing? What's the trick?

I replaced the slip yoke on the NP205 along with the bent driveshaft. It's nice to ride around without a seat massage.

I'm planning on doing the same with mine. Did you have to cut the fenders for the tires?

We drove to Hungry Valley in Gorman, CA. It was a lot of fun. Thanks for the complement.

We took out the M1031 for the first time in the dirt with the ladies.

I found this in TM -34 Step 1 Check for voltage at pink lead on fuel injector pump fuel shutoff solenoid while assistant cranks engine. There should be at least 9 volts. If voltage is not correct, trace circuit. (See wiring diagram E-3 or E-5) If voltage is correct, perform step 2...

I'm doing this now. LEDs have a positive and negative side. I haven't reinstalled the dash yet or I'd attach a picture.

This was the problem. Thanks for the advice. Every single wire was cut and tucked into the frame. I found and fixed two bad bulbs but now I have all the running lights, turn signals, brake lights, and reverse lights working! Now to reinstall the dash and charge the batteries from all the...

Great suggestion. I found a bunch of cut wires back there. I'll look up the diagram and see what's going on.

I don't have a rear bumper but I do have all of the switches in the dash. On the service light switch, the on and blackout modes seem to work. Are you talking about the switch on the far left? If I don't have a rear bumper, should I bypass the left switch with jumpers until I can get a bumper?

I have a switch on the dash for the lights but I don't have a rear bumper if there were any there. Where do I need to look?

I'm in the process of getting my new to me M1031 on the road. I've found the wiki link and I've downloaded all of the tm's I can find. I've started with the electrical system. Currently I now have working headlights (high and low beam) with the LMC style relay. I've replaced the...