Search results

I have a spare harness, It may have the plug. you could always just remove the military plug and use spade connectors.

RE: Re: RE: Starting below 0 degrees? also you could try to find the artic fuel heater. its a deisel fired heater that installs under the hood. heated air warms up the oil pan and battery boxes. Mike has the artic kit on his truck.

better reputation? please explain? I have yet to see a broken superlift spring, I have seen several tuff country and rough country springs break first hand. Superlift springs are stiffer than factory, but if you want mininal lift with big tires you want springs that dont flex, so you dont chew...

I live in MI, where is the deuce you bought?

For now: have them make up new spring packs for the front. yours are worn out i bet. you can have an extra leaf added. they can even add a short leaf (like a zero rate). when you lift it: if you want them to last, and not be weak. get superlift springs for the front. for the rear have the...

the 83.7mm

thanks for the confimation, ACE. I was hard to tell from the side view of the picture.

12v, and i think they only used the plastic body. this one looks close, but i dont think its exact http://saturnsurplus.com/lights/12vbouthead.htm

the TM should give a nice diagram of the pump with lines.

RE: Newb with more GPR questions sorry if your getting nothing out, the relay is bad.

RE: Newb with more GPR questions sorry to further test the relay, without the need for a second person. you can make a jumper to go from the small terminal on the GP relay (the one with the light blue wire) to a good ground. this will activate the relay. that way you can take voltage...

Re: RE: Need some advice on a hard starting CUCV that goofy guy, is gimpyrobb. I got the impact off of ebay, they are on there every once in a while. They are called RoboImpacts. Be prepared to spend ~$150 for a working one. Parts are still readily available for them. the brushes are the most...

i have a whole spare filter base with the sensors still in it.

fyi, if the blackout light switch is tripped, the brake lights dont work either.

the 6.2/6.5 starters DO NOT REQUIRE SHIMS!!!

RE: Re: RE: VIN Help if its a m1028, then it does indeed have the np205 and the detroit truetrac posi unit in the front axle.

isaiah you have a bad glow plug temp sensor, its stuck in the open position (the truck always thinks the engine is warm enough not to need the plugs.) I always get confused if its the temp sender on the front of the drivers head or in the rear. I'm sure mike will chime in with the correct...

you should be able to get that hose at your local parts store. its the same as the civilian truck and blazer.

mine was the grey pad when i got the truck, the vinyl spray works great, as now its flat black.

buy gm, its thicker metal. also before you install it paint the inner fender with some heavy duty paint.