Search results

DW, great link for body parts though

I'll dig through my TM and get the PN's in the morning, I doubt that you will find them anywhere but a junkyard or on ebay/through a member here though. I bet that it would prolly be better to take the old set (or whats left of it) to a local metal shop and ask them to bend up some new ones for...

great, if you need help,just ask. its what we're here for

SBD, your location is there now. I would be interested in an electric fuel pump off of one of the gensets, if they have one (some, like mine, had mechanical) I have a 10kw gasoline genset it is about 5ft long and weighs around 700lbs. Model # MEP-018 also, if there are an of the jerry can...

yeah, but they don't usually have a trailer ball built in to them.

are there any CUCV's or large gensets?

I would also have a chat with the shop that did your rebuild, should last much longer than a few years. Maybe they'll do it for a much reduced rate., It's worth asking about. If they give you guff then ask around here, odds are that someone on the forum has a spare rebuilt IP sitting on a shelf...

could you take a pic showing were on the IP its leaking.

gettin inline heater from ssdieselsupply, 1500watt inline with lower heater hose. around $50

I will be putting in a inline model from ssdieselsupply, its a 1500watt heater that goes inline with the heater hose that comes from the lower radiator. should make for almost instant heat too. get an outdoor timer too, set it for about 2 hours before you need to get up. There is no reason to...

it should bolt right up, although you should be able to get it cheaper through a local trailer shop or camping trailer repair shop.

no

Looks nice, too bad that their isn't a m1008 in the shot, and I won't be able to make this rally (at least this year)

looks like ya got a great deal on the truck, welcome to the site.

I wish I could fit one in the driveway, my mom would KILL me though. Hey Recovery, have ya had a chance to get the genset parts gathered up. ? Pretty Please. With Sugar on Top (It will be getting hot soon and that means the chance for brownouts)

sorry, I wasn't that descriptive. It mounts to the engine bay side of the radiator (but its a a seperate piece) its a set of tubes that run the full length of the radiator. (the one that hooks up to the oil sampler on the driver's side of the engine compartment is the side that is leaking) the...

the oil cooler tubes the run along the inside of the radiator on my truck has begun to leak a little from the back side of one of the fittings. I called the local dealer and the part runs $260!!!!! FOR A FRIGGIN ALUMINIUM TUBE.

I had to have mine done a while ago, as the ends were shot. ended up costing about $250 installed. and they even did an alignment.

he even sells a backage of the connectors that you will need to switch the gp harness, they are the good connectors ( the blue water resistant type)

put a multimeter one the wire contacts on each side of the resistor, should get the resistance stated in the above post, the voltage prolly killed the voltage sense chip on the controller card (this would make the GP's not cycle at all, I found out that one the hard way.) the relay might also be...