Search results

No call yet...

It's a non-thermal I do not know of any that you can simply disconnect when you want to. That does not mean they do not exist, I just don't know about them.

Call me, PM sent

Now, you are aware of this simple rule, right? Are you in college to learn, or just confirm what you all ready know? I ask this because if you are capable of learning, you are capable of learning to capitalize. I wonder how you made it through high school. The next time you are so lazy(or...

Question No. 1"How does a thermal clutch fan work?"A thermal clutch fan operates using silicon fluid as a viscous coupling medium. When the clutch is cool and disengaged, most of the silicon fluid is stored in the reservoir allowing your fan clutch to slip relative to your water pump shaft...

You need to either test, or ask them if they modified the wiring to supply 12v to the starter solenoid. Original it gets 24, and changing only the large battery cable does not change this. The easiest way to do this is, pull the under dash starter relay and place a jumper wire between the...

Do they no longer capitalize in college?

No. You'll need to remove the original and install and electric fan, if that's your goal. But, an electric fan will die fast if submerged often. Maybe you need a snorkel.

So, your still supplying the solenoid with 24v? Did they install a starter brace/support? Did they give you your old starter back? I'd simply replace the bendix housing on the old starter. Do you have a good starter repair shop near you?

FMJ posted a cam replacement thread once, you might try looking for it for help. edit, found it http://www.steelsoldiers.com/showthread.php?45917-55mph-detonation-post-mortum&highlight=cam There are 2 more on this topic. An advanced search for "cam", posted by "FMJ", in the Deuce forum will...

http://www.steelsoldiers.com/showthread.php?79228-TM-s-for-the-939-series-trucks

5306-01-148-6765 Features MRC Parameter Characteristics AAJD Thread Class 2A AAJF Thread Direction Right-hand AASA Thread Length 0.800 inches minimum AASB Fastener Length 0.930 inches minimum and 0.960 inches maximum AASK Head Style Hexagon extended washer AASU Head Height 0.259...

Should be in the -34PTM.

When you install the tensioner, be sure to shim it if needed. Do not try tightening the bolts to close the gap at the ends. They usually have at least one shim/plate.

What is the going rate for a tensioner?

Well, if the vertical bolt spacing is 1.75", then the top set of holes should mount the pintle hitch 5.25" higher.

There is no corresponding spline on the shaft, to match the missing spline on the slip yoke. In order for a shaft shop to index the splines to the opposite ends U joint position, they will need a/an(original) slip yolk. The blank spline serves no purpose.

Found on a driveshaft shop website, http://www.dennysdriveshaft.com/frequently_asked_questions.html

From what I recall, there is no significance for that one missing spline.

Whoops, sorry I made an error. TM 9-2320-260-20P