Search results

Have my New C Pillar in and dry fitting the turret support ring. On the 5th bumper to the C Pillar does the tongue slid into the support ring or ????

Wondering the correct location for a Bridge Plate on a Humvee. Ive seen on the hood as well as on the brush guards. Which is the most correct? Assuming either but leaning toward the hood at this point.

Looking for a MX-3543 ; M1101 Trailer Boarding Ladder. Any ideas on where to find one?

Looking for a MX-3543 ; M1101 Trailer Boarding Ladder. Any ideas on where to find one?

Looking for a R-422 cover. Anyone know where one can be found?

Beginning my M1045 turret restoration project (100% of my turret parts in hand) and was looking for assistance on the proper C Pillar replacement/upgrade process. I believe I will need to remove at least on SPONSON. Having never done this before I believe I need to remove a small riveted...

Wondering the best way to remove old surface mounted decals on the outside of the speedometer. ( noting trailering and MAX speed). Mine is cracked and flaking but don’t want to scratch or oxidize plastic when replacing.

Looking for a Turret Support “crows nest” B Pillar for a M1046A.

On my tailgate I have two rows of fasteners and wondering what they were used for.

Wanting to tap into 24V by using the battery box buss bar … concept is to tap positive off of buss bar and ground via negative buss in battery box area. Doing this inside the battery box vs using pos/neg polls under transom for ease/accessibility. Plan on using a CX-10071 Cable to connect...

Looking for Amphenol 10-350611-2P MIL-DTL-5015 (MS3100-MS3108) connectors or something similar to the attached photos as my MX-7777 mounting location (lower radio tray) doesn’t have enough clearance with standard barrel power out cables. Way too emotionally attached to the solution I’ve...

Wondering if I can use a MX-7777B/GRC to output power to a 12v buck converter? Don’t have the TM (yet - as they are hard to find) but concept is to draw power as if one were powering a radio tray but rewire a load cable to a 12v buck converter. this would allow me to have a master 12v system...

Are there Harris RF-5800-MP radios or working replicas readably available?

Can one look up unit/service history using a inventory ID number ... USMC M1046a

Wanting to remove overspray from a military paint job ... what should I use? (info plates / Engine parts etc) thx

I believe I may be low on power steering fluid ... thought the humming was at first the 200amp alternator but now believe it to be low levels of power steering fluid. I have confirmed my Cadillac Valve needs to be replaced as it doesn’t output the proper Oham readings (Fan clutch won’t engage)...

Three power washes, hung 2 X doors, installed new fuel gauge, installed new head lamps, diagnosed a faulty Cadillac valve, installed antenna mounts on tail gate, installed side mirrors and otherwise had a blast working on the Humvee!

I have an A1 Series Brush Guard (and L brackets) which I want to put on a 2003 M1046A. Question is if this is a valid configuration for my vehicle and what additional brackets I may Need to do this?

What are the correct antennas for a M1046a TOW Slantback? Mine is to be delivered Monday. Is it a MX-6707? Would this be used on the Slantback or on the transom of the truck?