Search results

I inspected my brake lines and they are very rusty, anybody changed the whole brake lines, what was the cost and do you have any hints on this job?

So I read some threads about this PVC or CDR valve and still is not clear, I took it out and oil came out from inside (10 mml), I blew in the inlet and there isn't any restriction, zero differential pressure. Seems to me that any exhaust from the oil cap will go in to the air intake. So, is...

Hi, CUCV lost some bolts and destroy part of the cover, high vibs and loud noise, I wanna try to put some new bolts back if the threads are not damaged and give it a try. anybody has the part number for a set of these bolts (autozone, carquest)? it failed after my 5000 miles on the road, I...

Finally I clean the interior so good anyone could eat from the dash if you want, a couple days later I found a dust layer all over the dash, I had a closet look because it was shine and gray-black colored and I can confirm is brake pad material, I check my fenders an all the plastic...

Steering and breaks are working good, I used a quart steering fluid every week (500 miles) to refill it to give and idea of the dripping. I put ½ quart of lucas steering stop oil and the leak slow down pretty good but still dripping. Of course is annoying having oil inside the compartment...

I found this on youtube Spend 120 days on the road with Dave and The Pegger (jeffuehrer) as they make their way around the country. Armed with a CUCV M1009 military blazer, generator, sub-zero sleeping bags, laptop and cameras. The first of it's kind "trekumentary" captures the true spirit of...

I just removed the caliper, but the rotor is not coming out as easy as all the youtube friking videos showed. 8( Do I need to take the whole hub out first? I’ll post some pic in a minute thanks

I asked at NAPA but they sell the whole injector kit for 80 bucks, but only one injector is leaking, Can I put coper or crush washer that fits on the injector or any soft sealer?

http://www.blazerchalet.com Hi, has anybody been able to get hands on one of these? Is there any out there with an after make truck camper that fit the cucv?

Pink wire at IP, can I use this with a relay 12V 40Amps as starter cut off? I was thinking to install an alarm with a relay to open this pink cable on the Injection Pump as another option to secure the truck while park in public places. Anybody did it here? Any ideas? I prefer no to use...

Anybody has a napa or autozone part number for this gasket? thanks

Mod: http://www.steelsoldiers.com/cucv/36435-my-cucv-spin-fuel-filter-mod.html I just put Pawnshop spin on modification, I filled the filter half with diesel kleen, crank it with the PI pink cable disconnected to fill the other half with diesel, put it back but It did not start, then I open...

For the two alternators I found holes in the bracket where I can put a screwdriver as a lever and adjust the belt where I want it, but for PS belt is there any trick?

So this one came with the pulley diameter smaller than the original, I could not adjust the belt, I even tried to move the power steering pump away to tense the belt, but the original belt is to long. I did not want to remove the pulley from the original to the autozone, what have you done...