Search results

In the process of swapping out my 10 bolts for a one ton setup. And im puzzled Finally found a guy on craigslist with a dana 60 front that has the passanger side pumpkin however it's not a chevy dana 60. Off a dodge w350. Will this front end work or will I have to find a d60 front off an old...

Just finished the fuel filter conversion on my 1009. Followed all the instructions and it fired right up. Went inside for a half hour or so then headed back out to discover a nice big puddle of fuel under the truck. All my connections are solid and no leaks are coming from the new filter or...

Over the winter I snapped the rear passenger side axle and got it all fixed up. Bought a kit from summit with a bearing, seal, shaft and new lugs and studs. Put about 800 miles on it since then. Recently I've noticed a rubbing noise whenever I turn left and the harder I turn the louder the...

Had a caliper go out about a week ago, changed it and everything was good until this morning. Had almost no brakes and discovered a slight puddle of fluid on the ground under the caliper. Bled the line and their still very spongy and I cant seem to figure out why it's leaking. aua

Long story short, broke an axle shaft on my m1009, bought a new shaft, went too put it in and rounded the bolt that holds the gear pin in. I have no idea how to get it out and need my 1009 running before tomorrow as its my DD.

I just bought an offroad light kit and got it all mounted and wired up but I have a question about the power source. Their 100w lights and I don't want to wire them to the fuse block. That being said, would it be safe to run the power wire off one of the positive battery terminals? I know it's...

Title says it all. Repainting the 1009 soon and I cant decide between OD green on the whole truck or the three color woodland camo scheme thats on it now. If any of you have pictures of your paint jobs post em here or just any opinions on paint that would match the military colors. I hear...

I had a few questions on the rear power hookup in my m1009 and figured a few of you more experienced CUCV owners could help. There may be a thread on this already but I did not see one First question, and I'm just thinking out loud here but would it be possible to cut and wire up an extension...