-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
Search results
-
C
How long does the Primary Fuel Filter drain For!?
I've been sitting here for 20 minutes..it keeps going. I wanted to replace my fuel filters but at this rate.... what the heck -
C
Is it always in 6 wheel drive?
I drive a Wrangler with a '4wd' indicator.... I THOUGHT my deuce engaged FWD in addition to RWD when I hit the little air solenoid under the dash which states ' front wheel drive' ... but in the TM I just read, it says that's for deep water fording and actually just pushes air to I believe it... -
C
Steering Fluid, Gl-5 okay?
Hey guys! :) Wanted to drain the steering fluid because I have reason to believe it's been 20 something years. lol. I dont have time to go through the TM today so does anyone know off-hand how much and/or the type of fluid it takes? I heard theres no way to drain 'all' of it, but I figured... -
C
oil drain plug gasket too small? what do I do.
the copper piece is big enough to go around the inner diameter, but the threads are simply too large. .. any ideas? -
C
86 M35a2 with a '66 engine? Is this possible?
The PO says this is the original engine... so is the truck's year a lie? or did the original engine get replaced with an ...older .. one..? -
C
Turbo Intake Hose Hump (coupler) Dimensions ???
Hey guys, Mine cracked wide open so I need a new one. I'd rather not spend 40+ dollars on it ... http://www.tnjmurray.com/militaryvehicles/index.cfm?shop/product/id/9E39B622-5056-A361-125F79D1F187A338/catid/3F188FFF-F448-5729-D4BA2838D92E9730 So does anyone know the dimensions? I believe it's... -
C
Rear Wiring Harness - m35a2 - fabbing one up?
Hey all, Can't seem to locate a pre-made wiring harness for the rear, only the front... Soooooooo.. where can I find all the new wiring and connectors (mainly concerned about the connectors) to basically 'create' a new harness? Thanks guys! :) -
C
Rotted Radiator Mount & cracked intake to turbo pipe
Guys, where can I find a new radiator mount? the one that sits between the frame & radiator on mine is totally rotted out & the intake to turbo hose is cracked and dry rotted. Where can I get these? Thanks! -
C
Transmission Oil - 80w/90 vs SAE 40/50
I know there's just about 10 million threads on it, but I've gone through them all & they ALL show different answers... I'm looking for a smoother shift & an oil that will perform to the best capability. I heard that SAE40/50 doesn't have extreme pressure additives, while someone else said... -
C
Air Compressor ? oil out the drain tanks
Hey all! received my new to me deuce! :D :D :D however, after starting, operating, etc. I eventually bled the air tanks and they... leaked oil all over the ground....???? any idea as to why? Thanks! -
C
Rockwell Fluid Replacement
Is it possible whilst leaving the rear/front end connected to the truck? I see the diff cover is welded on... Thx -
C
Rear Mounted Intake??? Why?
Hey all, I haven't received my new truck yet but the PO said the intake was relocated to the rear directly behind the bed... anyone know why? what purpose this might serve? but mainly, is it gonna reduce my turbo whistle? :( -
C
Stock LOOKING EGT/Boost gauge?
anyone know gauges that look similar to the stock deuce gauges and are 'relatively' inexpensive? -
C
Deuce WMO setup in pickup bed?
Hey guys, I haven't even received my new m35a2 BUT I'm excited to burn up a whole crapload of WMO sitting in my garage. I also have a good source and an ehhh- sorta okay source for oil once in a while. I need a lot of input here. Please dont respond 'look it up'... I've tried for the past few... -
C
AFE/K&N air filter
Hey all, Im new to the forum I just picked up a deuce from ebay, quite excited to get it!! i want to run it with lower egts to keep it running longer. I read a post about a k&n filter allowing more than cfm that fits on the 465 multifuel but I prefer AFE more and they seem to have better...