Search results

thanks for the reply. I tried with and without bulb in the turn lever with same results. they seem to be wired correctly as the turn signals come on front/rear and the bo work as well just don't blink? I'll take the flasher unit off and clean up the ground. I used my air grinder with 80 grit...

Sorry I just saw these replies. I put all my incandescent back in my truck except in dash/cab and everything worked. I waited till I got my replacement stock led brake and turn signals and then tried again. After installing new led turn signals and brake lights same results. They just light up...

awesome thanks, any way you can check the voltage with the panel unplugged from box. I assume it's 24 volts.

cool I'll take a look tonight, thanks. No one knows the specs on the solar panel or pinout for the plug??

I didn't even think they unscrewed, I'll have to check that out tonight. Is everything there to attach wire on the other end or do I need to purchase the other half of the connector.

Thanks I was looking for more of what type of connectors they are not how to connect the system. I know how to wire it but I don't want to have to cut off the ends because I don't have a way to connect to yellow connections. I would like to have a charging feature.

I have everything but the solar panel for the pulse tech charging system. Does anyone know the pinouts for the solar panel input and the wattage/voltage of the panel. I going to try and find one on ebay. Also, what type of connectors are the yellow connectors?

I've gone through all 5 TM's and I can't find anything on servicing the winch on my M925A2. I just want to make sure fluids are good in it but I can't find anything on it. I had a couple questions in particular. What is this on the top left of the winch and I have also seen these on the...

Like I said I replaced ALL the bulbs including the one behind the switch to led and I even have it out right now. The only light I haven't replaced are the backlights for gauges. I'll take a look at the module tonight and see what version it is. Thanks

Anyone have the part number for the updated flasher unit or a way to tell which is which. I'll keep testing I've changed just about every bulb out to led that I can easily access.

I replaced all my light bulbs inside and outside with 10-30v led bulbs and my front signals are acting up. When I read the voltages on the lines I get 16 top, 24v middle and 6v on bottom lamps on the front turn signal. Also, when I turn on the signal it just lights up and doesn't blink. I...

Midway through this thread it turned into a pulsetech thread for a minute. Anyone know a replacement solar panel for the pulsetech system, voltage, wattage on something that I could wire into my push button controller. I have the circuit breaker and push button controller but would like to...

thanks I wasn't going to do anything without researching first.

Awesome thanks,sometimes searching just doesn't find the result u need

after I turn my truck off and have the spring brake set I can hear a small air leak on my back right air brake. It is leaking at location in picture. Could this be a seal or diaphragm? The brake is holding but wasn't sure if this was part of the spring brake or the air brake which was...

High water in M925a2 5-ton 6x6: http://youtu.be/IBRCDpGvLAg

ah I didn't even think about the CTIS, that's what it is, darn I was hoping I had fording kit :-)

I have been searching through the repair manuals looking for these hoses that are run to this top sides of each of my differentials and can't find what they are. I'm wondering if they are low pressure for fording? I don't have a fording lever in cab but do have snorkel and the plug for the...

butt post I guess.... funny

Vovlomuy C C j I GFC vg CV free free roll cpkmlchhgk HGH