Search results

I have changed the g749 transfer to two speed several times. You need to purchase the large diameter low gear out of a g508 banjo transfer. The top sliding gear must be narrowed to 1 7/16 inch so you can neutral. Transfer case must be modified slightly for large replacement gear to fit. I have...

BLeed the injector pump at the top front inside between the pump and engine block

need fuel pump repair kit for m series gmc from butch atkins

Have six dukw eighteen inch wheels and spacers some usable tires

The rear hubs can be flipped but you have to have a different brake dum adaptor,like the ones on the front axel. Much eaiser to put hubs and drums off 135 axels. Ihave messed wilth m211s and m35s for years. I have used a gmc pretty hard. They are a toughfer truck than the m35. gmcs have stronger...

I have converted several gmc's to standard transmissions both four and five speeds. To make a good truck out of them you should convert the transfer case to two speed . I have one truck with this combination with a three hundred horse power chevy v8. Truck groses 36000 pounds. Have never broken...

Put a 327 or 350 chevy carburetor on your gas m35 and it will run great. They work well on the GMC M series also.

In regard to flipping the hubs on a GMC m series. This truck is much more difficult to switch than a m35 or A2. The GMC requires different brake drum adapters the m35 does not. You have to have brake drum adapters like on the front of a GMC to switch the single hub 135s to dual hubs. Also a lot...

Chamfer the other side of the wheel bolt holes on the 1100 single rims and put them on dished out. If you mount them that way on an m135 hub it will be too wide. Just right on a m 211 hubs

Put a 6 cylinder chevy rochester carburetor from the mid 1950s on your m37 and you won't believe the difference. They start and run better with more power and no flooding over. Can't remember due to years back if you use one off a 216 or 235 cubic inch engine. The bolt holes are futher apart on...

I have a good set of side racks with troop seats and top bows for a m715 for one hundred fifty dollars .G. E. Rork Horton Kansas 785-486- 3350 email gerork@live.com

have been told that Granger has them for HH As568A-227 andAS568A-230 Don't know for a fact because have never tried them

rainbow tigerfan I would like to get in touch with you. I live sixty miles north at Horton. I am Rainbow on steel soldiers G.E. Rork email gerork@live.com

Rainbow Nice to see something happening in Kansas. I'm a farmer ,busy time of year but will try to make it. Have around twenty five trucks collected since 1970. G.E. Rork Horton Kansas

Nice to; see something happening in Kansas. I'm a farmer busy time of year but will try to make it .Have around twenty five trucks. G.E. RORK Horton Kansas

You canget ahold of me by listed email under Rainbow

to ksm715 three star general I have lots of army trucks. My email is gerork@live.com

I have 5 chevys one correct bed located in Horton Kansas

I have 5chevys one correct bed located in Horton Kansas

I don't think your fuel pump kit will do me much good . Both pump and motor run .I just need the rubber gormet at the bottom and the four little rubber mounts that hold the pump and motor assembly to the square metal frame and some gaskets .Thank you anyway for replying. Rainbow