• Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!

  • Microsoft MSN, Live, Hotmail, Outlook email users may not be receiving emails. We are working to resolve this issue. Please add support@steelsoldiers.com to your trusted contacts.

 

Search results

  1. fasttruck

    M816 (M809 Series) fuel pump drip

    This one leaked bad at idle and leak dimished as engine loaded up. Fuel came out of vent hole of flange between air pump and fuel pump.
  2. fasttruck

    m818 trans swap??

    You will have to adapt the air controls on the transmission cover that sync the transmission and the transfer case together as to direction of travel to use a none stock transmission in a M809 series truck. Also measure length of intended transmission to see if it will fit between the engine and...
  3. fasttruck

    Anyone near Baxter, TN want to look at a deuce?

    It will likely cost $1.00/mile to move a deuce at today's fuel prices. Wait a week and it will be more.
  4. fasttruck

    New member

    Winch is not stock for a front mount winch for a M54. Appears to be a rear mount winch from either a 5 ton wrecker or a 10 ton tractor. No dog clutch. That means power in and out. Whatever power take off and direction of rotation controls will not be covered in the TMs which would describe the...
  5. fasttruck

    New to me Deuce with matching trailer - wrenching post

    Get a lubrication order and read it. The key to survival with a vehicle with manual steering is lubrication. There are over 30 grease points on a M35, 4 on the handbrake alone. When coupling the trailer make sure to hook the hoses up correctly, they are not interchangeable and open the valves on...
  6. fasttruck

    Is it true of all the slews of bugs that the deuce has?

    Gert a lubrication order and read it. The key to survival especially on a vehicle with manual steering is lubrication. A deuce without a winch has over 30 grease points, 4 on the handbrake alone. Neglect them at your own peril. My most recent deuce was neglected in terms of maintenance by the...
  7. fasttruck

    Dating my deuce?

    It5 isa possible the engine was swapped out and the exchange engine is newer than the chassis. If the axles or transmission have older dates I would go with the oldest date.
  8. fasttruck

    Shutting Down M817 Question

    You turn the screw clockwise to bypass the fuel solenoid and counterclockwise for normal electrical operation. It doesn't turn too many revolutions from one extreme to the other. With a stick shift truck like a M 817 you can put it in high gear and stall the engine to stop it if you don't want...
  9. fasttruck

    What have you done to your 10 ton this week?

    I was advised by the resident 10 ton guru to try to maintain engine speed as close to 2700 rpm as possible as that was the diesel engine's "sweet spot." On flat ground they would run, I had a M123/747 combination going 45 mph into Ft. Dix, NJ with a M60 tank on top on Rt 88 which is essentially...
  10. fasttruck

    Why so hard to shift gears

    Clutch pedal has the specified free play listed in the TM? The M 37 here is distinguished by having fairly short gear lever throws' when moving front to back like between 3rd and 4th gear. However, the neutral gate is so wide you think you are pushing the lever out the passenger's door when...
  11. fasttruck

    New member from Portland, OR. Just picked up an m715.

    Read the reading. There should be a data plate in the cab that identifies the applicable publications. You need a operators' manual organizational maintenance manual parts book and a lubrication order. These may be available in the TM section on this site Grease is cheap Parts cost money Be...
  12. fasttruck

    New guy from Arizona

    Remember these 500 gallon water tanks are typically not baffled so we hen the load starts to surge side to side as when turning a corner at speed ypu are at risk of rolling the truck mover. This is a common problem with fire departments that make a deuce into a brush truck and then overload it...
  13. fasttruck

    No brakes

    The -20 manual says start with the master cylinder then work your way down the line, hydrovac, slave cylinders etc. I had a mechanic replace a hydrovqac on the side of the road when stopped with dragging brakes on a M52A2. Went 100' and brakes dragged again. Replaced master cylinder, problem...
  14. fasttruck

    Towing an M1009 Blazer

    Download the applicable TM which is available on this site and read the section on towing procedure which should answer your questions. The military would normally flat tow a disabled vehicle.
  15. fasttruck

    Is this a real surplus unit or a add on

    The wrecker looks like it is capable of picking up something heavier than the truck underneath it will support.
  16. fasttruck

    Firetruck from Winslow Township, NJ to Preston, OK.

    Fire trucks typically have tall rear axle ratios and most of them max out at about 52 mph. They are not designed to be interstaters.
  17. fasttruck

    New to the game

    Aas in post 3: Don't make a move without the pubs. Read the reading. Military CUCVs are not completely identical to their civilian cousins especially in the area of electricals and if yours has a 24 volt charging system which Army radios require.
  18. fasttruck

    Tire pressure

    Remember M 101s have no in motion brake. Just because you can get it going doesn't mean it can stop.
  19. fasttruck

    Another stupid idea, ignore this thread.

    Air dryers remove moisture from the brake system so it does not freeze in cold weather. The Army issued a kit for M35s and M818s and such that would meter alcohol into the air system to prevent freezing. You still had to drain the tank daily tom expel the moisture. An air dryer would ne more...
  20. fasttruck

    Rear tire removal help

    You put the outer wheel on the ground lock ring side down with a block of wood under it. Hopefully you have an impact wrench for this, turn in thimble, one part with the square head, in the direction to tighten it. If the wheel was on the passengers side this would be clockwise. The thimble...
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website like our supporting vendors. Their ads help keep Steel Soldiers going. Please consider disabling your ad blockers for the site. Thanks!

I've Disabled AdBlock
No Thanks