Recent content by dangier

Guyfang, Close to you... I joined the Airforce , October 14th, 1972., as a LEO David

Guyyfang, Many thanks for the link for the updated schematic. Helped me greatly. Working on stuffing the innards back in one of the 003a's phase change box. Of course it does help when working with the CVT-1 and CT-1, it pays to know the difference between a C2 and a 2C ( also pays to pay...

Guyfang, Thanks for the info. Will work on it ltr. David

Hello everyone, I have most always tried to resolve my issues. This one has me over a barrel. I am replacing a 003a CVT1 and CT1 transformers. Tried to do this with them inside the output control box. That did not work as the wiring isn't long enough to do this. Ended up pulling everything...

Cube, How tight are you getting the delivery valve holder? I have had to tighten the holder beyond spec on a few units to get the ip to make enough pressure to start. Also have never had to use grease to hold parts on re-assembly. They have just gone in the right place. David

Thanks also to the others that responded and helped. David

Kurt, Success! Found 24v power on the oil pressure gauge opposite terminal (one terminal counter-clockwise) with fuel pumps running. Moved wire, it started and is purring out there as I type this. Appears terminal designations are switched. Looks to be a quality constructed controller. I...

Kurt, I figured you would have an idea from the symptoms. I looked over M7 and did not see the "I". The wiring numbers on M7 did not line up (137Jxx). Will go over that area again tomorrow. Many thanks for the response. David

Kurt, Had some time today so I tackled your new regulator for my 803. Install was fairly simple. Just have one issue-when I start the unit, the power comes up ok, then when I release the start switch, the power drops off to zero. Being you have the experience with this, maybe you could point me...

IN

You mentioned starting fluid. That is a big no-no on these smaller units. I just got a 002 repaired and started after what appears starting fluid was used on it. Piston ring lands on #1 and #2 rings destroyed. Was lucky enough to find two serviceable used pistons. Good luck on your efforts. David

I have a couple of other threads documenting getting two 002's going that I purchased in a private sale. From rotating diodes to starter/flywheel replacement, and general cleanup, it has been a challenge. After diagnosing low compression on one cylinder (325 vs 465 psi), I pulled the head. This...

I worked on Capitol Hill and had an employee that was dyslexic. Didn't know about it until I caught him taking service work orders home for his wife to read to him. He does have a fantastic memory. From then on, I took him in my office and discussed each work order he was assigned. He can go all...

Looks like someone went to town on this one. Flywheel teeth were rounded over and starter teeth were half gone. Wonder how many times they tried to start it? Lends some credence to Guyfang's follow through with troubleshooting comment. David

guyfang, I do have 24 volts on one wire that was attached to P16. Compared this S7 to another from a donor machine. The copper strip seems stiffer on the donor S7 (contacts have more "snap"). Everything else on the switches looked the same. Both plunger's were the exact same length. Cleaned up...