Recent content by hbranchcreek

Only thing that would have made that vid better if you would have showed the stock hold up latch works. Great job I would love that on my truck.

Run motor with the radiator cap off check for bubbles or water rising and falling.

Make a 3120 look like a average size saw.

I'll call them tomorrow and ask them that's a good question .

didn't have any numbers

Sorry bought them from eastern they said they will send me the correct pins. I did have this problem in the past but can't remember the seller.

just got to measure the pins. The correct pin is 9/32 wrong pin is 1/4

Well the vender agreed with me and are sending me the correct ones.

You guys are rite I wish I had a way to measure them. I have an old pin and there is a big difference between the two. Just trying to help.

Your correct that's an old shaft just for comparison. The wrong pin is on left correct on right.

Can you see the correct fit next to it?

The only thing I have to measure them is a tape measure not very accurate but they look like a 1/4 in.

Hey guys,since this just happen to me I thought I would share this to help others. There are some undersized pins being sold by venders. I don't no the exact diameter they should be but maybe someone else will. These pins will break prematurely this has happen to me. I hope I did the pics rite...

I took the shear pins to avoid paying 30% restocking on the incorrect worm gear. The pins they gave me were wrong too. Now they say they have the rite pins and are sending them to me. Hopefully there rite and we can put this to rest.

This must have grabbed some attention I was contacted by the seller they said they found the proper shear pins an are going to mail them. Problem is I only got them to avoid the 30%