Search results

Only thing that would have made that vid better if you would have showed the stock hold up latch works. Great job I would love that on my truck.

Run motor with the radiator cap off check for bubbles or water rising and falling.

Make a 3120 look like a average size saw.

I'll call them tomorrow and ask them that's a good question .

didn't have any numbers

Sorry bought them from eastern they said they will send me the correct pins. I did have this problem in the past but can't remember the seller.

just got to measure the pins. The correct pin is 9/32 wrong pin is 1/4

Well the vender agreed with me and are sending me the correct ones.

You guys are rite I wish I had a way to measure them. I have an old pin and there is a big difference between the two. Just trying to help.

Your correct that's an old shaft just for comparison. The wrong pin is on left correct on right.

Can you see the correct fit next to it?

The only thing I have to measure them is a tape measure not very accurate but they look like a 1/4 in.

Hey guys,since this just happen to me I thought I would share this to help others. There are some undersized pins being sold by venders. I don't no the exact diameter they should be but maybe someone else will. These pins will break prematurely this has happen to me. I hope I did the pics rite...

I took the shear pins to avoid paying 30% restocking on the incorrect worm gear. The pins they gave me were wrong too. Now they say they have the rite pins and are sending them to me. Hopefully there rite and we can put this to rest.

This must have grabbed some attention I was contacted by the seller they said they found the proper shear pins an are going to mail them. Problem is I only got them to avoid the 30%

Thank you every one for you're post. what I have learned talking to other members is these big suppliers forget who got them there me and you buying parts. We need to support the small guys that sell parts a reasonable prices and care about customer satisfaction no big company's that want to...

Well they charge 15 a piece and they were wrong too. It was a used worm gear for my winch.

Thanks for the replies, I posted this hoping the supplier would see it and realize how ridiculous and bad business it was. There a major vendor on here that's why I didn't post who it was. You need to know what you're selling we all make mistakes but you can't sell the wrong part then want to...

When I took it back they couldn't tell we what it was for they said the crate they got it from said m35 then they brought out 5 more and they were all different had my truck for 12 years and bout a lot of parts with no problems till this back to my trusted suppliers

I took back my old part so they could match it up but they couldn't find anything that's when the 30 percent came in when I ask for a refund