Search results

Snow. How did you mount the bed crane to your bed? Did you put a plate under it? Also where did you put the camera in the back? over the pintle hitch? I got the other type of bed crane because the base was wider with 8 bolt holes and not as tall. I also picked up 2 more base plates so I can...

Changed it last night. It wasn't to bad. But, here are the things I would warn people new a doing it. When you put the boot on make sure the holes line up before tightening the ring. Make sure the screw on ring is the same size and the new one you have. The one on my truck was longer and...

I posted some that may work see here...page 3 http://www.steelsoldiers.com/showthread.php?107173-M923-receiver-hitch-assembly

I'm still trying to find out if there is a factory one made that's 29 to 33 inches.

All those route clearance lights must have been expensive. I went with a 250 dollar 52 inch light bar.

Wow...that's what I needed to know. Thanks SS55! I'll attempt it today and let you know how it goes. I'm sure I'll have more questions to make sure I did it right.

Not much input so far but this is what I'm getting so far (1)....apply adhesive to exposed zipper and fabric. Allow adhesive to sit overnight. What adhesive am I supposed to use? Can you use seal maker? Seal maker on the zippers (2) Discard safety wire (1). Where can you find a replacement...

How much grease do you put in it? I take it that you inject it into the grease fitting a the top?

good to know. I was going to replace both but only one is leaking

I looked up the TM and did a SS search but still have questions. (1)....apply adhesive to exposed zipper and fabric. Allow adhesive to sitovernight. What adhesive am I supposed to use? Can you use seal maker? (2) Discard safety wire (1). Where can you find a replacement for the safety wire...

Doesn't crank is if no electricity is getting to the solenoid. Batteries are all good and fully charged/maintained. Next time it happens I'll check the connection at the coil with my Fluke Voltmeter to see if its getting electricity. If it isn't it has to be the control box.

Was having problems with my truck not starting from time to time. It usually happens after I try to start it multiple times. The first few times it starts right up. but after I drive it and repeatedly turn it on and off there comes a point where it will not start. So, I installed a second...

my BOV has them. and so does my BO trailer

Wired the solar charger. Added a second starter system to bypass the box. and put the bows/cover on.

M813...how did you get the front and rear end on? Did you tie them to the bows? Still haven't figured that out yet

rolled it up inward so rain water doesn't build up in the fold

its making a little more sense. So, untie the sides. Screw the little straps to the metal angle that attaches to the bow. And weave those straps into the clips on top of the canvas. It that right? I guess the little straps hold the canvas to the angle of the bows.

Not sure what you are saying. Mine has strap clamps on top. But, I can't roll up the sides if the cover isn't attached to the bows from the inside.

Put the canvas on and it seems too long. There are straps pn the outside but no internal straps... So, how do you strap the canvas to the bows?

Better know how to drive well. Keep your fingers on the outside of the wheel. Start stopping far in advance. Much harder than driving a 5 ton that's 8000lbs heavier.