Search results

Found a feew cut vacuum hoses on my 1165 with a 6.5 turbo and not sure what they are for. They are cut on both ends and look like they were connected to something that was removed, does anyone know if they need to be connected to anything

Does anyone know what this harness was connected to, its the red and white wires on an M1165 A1 under the left side hood next to the blackout light and turn signal wiring.

Does anyone know what this harness was hooked up to, its a red and white wire under the left side of the hood on a M1165A1.

Does anyone know where I can get the air/fan decal for the M1165 humvee

Got a little acetone on my temperature gauge lens and now its foggy, I have a bad gauge with a good lens and wondering if theres an easy way to take apart the gauges so that I can swap lenses.

Is there some type of adopter available for converting the humvee light switch to rocker switches ?

Ok great, so I definitely need it

I have an 1165 A1, here's some more pictures

Does anyone know what this is used for? The harness pictured is connected to the negative post and comes out to this box at the rear left corner of the battery compartment. Relocating my batteries and wanting to remove any unused wiring.

Makes sense, Thank you

I looked at the wiring diagram for the 1165 with serial number below 300000 and couldn't find 40W, not even on model other diagrams.

Working on my butchered instrument cluster wire harness on my 1165 with electronic speedometer and traced most of the wires and marked them with the correct numbers. A few wires are not shown in the manual and im looking for some help on these. Basically 2 cut wires attached to my cluster...

Done, crossmember is back on and vehicle is running without issues, thank you

I have purchased new bolts and nuts for the crossmember along with a transmission mount and when I tried to install it I found that I need the 2 bolts that attach the mount to the trans, can you please tell me the bolt size for the trans mount

The bell housing crack? Im gonna have it welded.

How about the driver side is it the same?

I just received my new crossmember and trans mount but not sure what size bolt was it that mounts the crossmember to the frame

This is very helpful, thank you

These are the 3 wires that attach to the side of the starter. Unfortunately they were cut before the tag and im not sure if I actually need them, the start does work without them

Hello, I have the same issue and replaced the relay and the trans light stays on. I disconnected number 3 and the TCM light stays on, I disconnected Number 2 and the light did not go out, how do I do the third test?, also all the gauge cluster wires are cut and butchered and thats probably why...