Search results

I have a 45 CCKW all stock, went to start it yesterday and it coughed and died. No spark, I think it might be the coil. How do I test my coil, and if it's bad where can I buy another?

I have a 1944 split type axle,I'm deep in the front axle restoring a neglected front end. Need to replace the steering knuckle felt seals. Anyone know where it the U.S. I can find them?

I pulled one of my Timken Transfercases, I want to go through it and replace seals or what ever it needs. any tips on building a stand for it all the way to replacing parts would be greatly appreciated. thanks

Is there a way to test my temp sending unit? The TM says to replace gage and sending unit both at the same time. If so where is the best place to get one?

I pulled a # off the right side of the frame on my 353 what can you tell me about it? looks like: CCKW 353 I59400 47

I was looking at the REAR SPRING SEAT BEARINGS reading the tech manual, still not sure how to properly grease them. Any help from those who have done it?.

Where is the best place and what is the type of OD variant for my 44CCKW and where is he best place for tires. Coker? Lucas? thanks

I think my M37 has a stuck valve I didn’t start if for the summer and now when I start it, it misses. Have to throttle up to keep it running fuel pump is recently rebuilt by Midwest military. I also rebuilt the carb last summer and it ran great after. how can o check and if so do 8 have to...

Does anyone have or can take me a few pictures of an open top dashboard? im not sure which holes are original. Can’t find any on the tech manual either thanks

I'm to the point of the restoration of my CCKW seats that i need canvas. I have used Beachwood Canvas and Od canvas.com but I would like to buy the canvas by the yard. first anyone have a place to buy the correct canvas by the yard outside the above mentioned companies? second I have some of...

My M35 has developed a leak on the front drive axle. It dripps on the outer wheel, best guess as to what seal I will need to get and where is the latest best place to get good prices. I have used Idaho motor pool in the past.

I just bought a cargo cover, any tips on use and installation?

Any tips on rebuilding my M37 fuel pump? my oil smells like gas, may have burned the barings.

what tips does anyone have on removing the bell housing on my CCKW engine? its badly greased over and Im not familiar with it.

my M37s oil smells like gas. I was told that the fuel pump may go bad and do that. The part that worries me is it wont start and the engine wont turn very fast. I was also told that gas in the oil can ruin barrings. I hope not. please let me know ideas.

Im new to the deuce game, i have owned mine now about 4 months. The previous owner was a diesel mechanic and was good at alot of things. One question I have is he used regular dot 3 in the brake system rather than military DOT4. How big a deal is that? I hope i don't have to drain and flush...

I'm needing CCKW engine pictures so I know what to paint everything under the hood. can anybody send me some?

where can I buy an M-16 mount for my M-35?

I bought my M-35 on July 3rd. It has been repainted and I want to remark it with proper markings does anybody have pictures of what I need to mark [stencils,decals] the inside as well as out? I looked on the TMs here on this site but cans seem to find markings. any help would be appreciated

I recently purchased an M35 need touch up paint Where is the best place to buy? It is a 1970 but is painted in camp black and green