Search results

I spent the day after church taking in firewood. Currently that is my only heat source. This is the trashy wood I sorted out of my wood pile while I was splitting and stacking now I need to get some helpers hete to stretch the tarp out on the pile. I have a few of the water bladders and they are...

I have soaked the right vent panel in Armor All the past 2 days . It suits me now and passes my QA. I also located a high idle magnetic switch for a member here. I tested it and it pushes the rod out . Havr a Great Day.

I loved the Goodyear Duratraks on every vehicle I ever put them on. My Trail Boss is OEM equipped with these tires and I have 39k miles on them and they are still 9/32 tread. MTR were my favorite tires, but time has passed, and they went the way of the Wild wood weed and Dodo bird.

I can thank Mr electric heater for my comfort and ability to make progress. I just hope the electric meter stays attached to the house as the meter is spinning out of control. I am always happy with the CUCV stance after replacing all 4 leaf springs with stock height springs. After 40 years...

I think I will call it a day. I made great progress. I still have the Wild Weasel wintering over here. I need to pressure wash and paint the rear frame section before I install the new lift springs. I don”t see that happening till spring. Take Care and have a Happy New Year. If weather permits I...

Sezzo I tried painting Bremsfreigabe but my hand was shaking too much.

Abracadabra. No smoking mirrors. Just good old thinking and trying things.

Experimental only. Judge not , and you will not be judged.

This M1009 is a 1984 model built 08/1983 the cables that ran to the rear radio were run on top of the floor. This hole is 1 1/4” I used a standard hardware store steel plug and painted it to fill the void. I was going to weld it shut early on but wanted to retain the stock hole. I hope you are...

B pillar plugs. Hardware store the ones that were in there turned to chalk dust. The left panel was tight I had to hammer it in. I think that will get thru QA. Quality assurance. Later.

Rough day I wire brushed my nuts , washed and painted them. Lunch time.

28 MT gear reduction starter. 28 MT support bracket. 24 MT support bracket ONly picture I could find of the OEM direct drive starter; I hope that helps. If not ask again. Happy New Year.

Honorable mention. After I tormented myself for a hour my Son stopped by and put a new grommet on my E brake cable where it passes thru the floor. Very nice. Happy Dad.

Good time to stop for the day. No use over doing it. Under hood brake hydro boost is all reattached. I have the left vent and E brake all hooked up and attached. I think that is enough for 1 day. I currently only have wood heat in my home and need to fire up the boiler. All the pedals are...

It passes my quality inspection now to install it.

Hand picked from inventory. The original ones I tossed they had CARC broomed on them. I Shall clean and report back. Jonestown is in the 50s today

After 2 hours and hand picking every fastener I have progressed this far. I am cleaning a left vent.

I will check back later.

These are a few of my favorite things. When the dog bites when the bee stings, when I’m feeling sad. I simply remember my favorite things and then I don”t feel so bad. Happy New Year

Just use lock nuts the crimped type. I took them off many times they are not as easy as a few bolts. Where would it sit to allow time to remove it?