Search results

Had WRONG info

Yes on the dog, he is YOUR responsibility, a lot of dogs are brought

PM sent

No pedel means no fluid, fluid has to go somewhere, CKECK WHEEL CYLINDERS, FILL the mc, pump, pump, pump then LOOK on the back of the wheels, at the backing plate, LOOK for a LEAK, if no leaks THEN look at the FRONT of the mc. there is NO secondary mc., think of the brake system as the same as...

Link does not work

The steering column trailer brake control does NOT activate the emergency air but works the the same as stepping on the brakes as far as the trailer is concerned, in another words, a hand control for the trailer service breaks only. Are you sure you have the air line hooked up correctly Are...

There is NONE on a m818

I have seen pedals moved up and down, but not out towards the firewall

I would do duels, this will give you FIVE spares, only a flat front tire will stop you on the side of the road, with singles ANY flat tire WILL stop you. You can run 1200x20 durls on a deuce

Just curious, any of you guys that are planning to drive the trucks home HAVE insurance on them, since they are a UNKNOWN truck that has been sitting for quite a bit

It Would do the drop side, it will be more versatile

First thing ADJUST the brakes, that WILL take some of the "soft" out, if still to soft, bleed, my 819 sat TWO years, engine could not be started, my brakes NEVER changed from the good pedel it had when it got shut down. I would wait on the mc kit, if there is a leak, it will be most likely a...

You would have a lonnnnnnnnnng front drive shaft if you move the transfer back, also will it clear the power pack, could be hard to power a front winch if you have one Well I went up and read the black type (does not show up on od background), see you have come the this same conclusion

The top plate problem in that it is a flat plate on a flat plate, no seal in between, so even if the center grease access hole is tapped and then pluged, water still can intrude from the edges of the plate, if the plate has been on a while, you might find it has a slight bow in line with the...

On Swiss,s m62, I packed grease under the two top retainer plates, then installed the plates, so far NO water intrusion

To simple

I said in post 5 that you need to check for a vacuum leak, another 4 or 5 members said "LOOK FOR A VACUUM LEAK" and where to look for it. Finding and fixing a vacuum leak is cheap. if it was the float, it would NOT run with the choke closed.

LOOK for a VACUUM leak

Come on you two, how ablout BOTH of you take this as close to FACE TO FACE as you can like MEN, back and forth on SITE gets nothing done. I have more thoughts but that has been covered already.

I would READ your states DOT requirments for commercial use