Search results

And I'll bring my Snap-on 1/4" drive set too. With both sets going, we should be able to finish the job between lunch and supper!

cajun, send him a PM, he may not be looking at the thread!

With a deuce motor in it, 3150 pounds.

Shipping containers will collapse on the sides and in the middle of the roof when buried in dirt. The strength of the sides is in a direct vertical load, and the roof part has almost no continuous load bearing ability (it's safe enough to walk on). If you put steel beams on the roof, side by...

Got some big tow bars that need a good home. Two with feet are $200 each, one without feet is $150. Anybody need to pull a track (dozier) or log truck? will only load if there is an interest as these suckers are what the Army calls a four to six man lift.

Stan, The overall length from the top of the hook to the bottom of the pin is 79 inches. The spreader bar has a minimum length of 30.375 inches, and will extend between 1.25 and 2 inches to tighten the roof up. All of the .25 inch diameter tips are one inch long. Side rails are made to fit...

Cool Beans!

mikev, picture #5 is for a HMMWV, goes between the passenger compartment and the 'bed' behind the rear seats.

Measurements on military stuff is available in the TM's, if you are diligent. And, if you want the full specifications, do a Google search of the NSN. You will find plenty of sites that will provide that information, for a fee. I just looked up some connecting rods, turns out they are for a...

Stan, The drive should have been delivered at least a week ago, according to the Post Office.

If you are going to leave the GI ceiling lights, open them up, take out the glass, tape up the socket and spray high temp flat white paint inside everywhere. Make it much brighter. And if you are using filament bulbs, get some rough service 130 volt bulbs. If you use the white paint, 60 watt...

The PU is simply a combination of a MEP generator and a trailer (it stands for Power Unit). What you need is the two TM's one for the 20 KW generator, and the one for the trailer it sits on.

Keep the battery separate! All batteries create fumes that corrode electronic parts, some just do it slower than others. Even 'sealed' batteries leak at inopportune times.2cents

Welcome, glad you joined the site. Hope to see you back out at MVCSC and at the GA Rally.

Tim, Stampy needs roof vents, I could use some hand rails, and probably the jacks. Bring all the small parts to the rally and you probably won't go home with them!

delete, duplicate post due to poor internet connection

You will need an AM-2060 for the PRC-77 to mount onto, then an MT-1029 for the AM-2060 to attach to. The antenna base will be the MX-6707. You will need both an antenna cable and a power signal cable to switch frequencies between the AM-2060 and the MX-6707. Both of these will depend on what...

Scepter in Canada has made fuel cans, never heard of Spector making them. Diesel spouts are a big no-no in the USA because of California Air Quality Regulations imposed on all states by the EPA and DOT. However, they are available in Canada.

Looks like the Technical Manual is TM 5-4940-225-12 (1971), available on Liberated Manuals.

Sign me up for two pails!