Search results

KK, Looks like a nice shelter, but we need more detailed pics of the front faces of the units to be able to help you. Here is the type of picture that might be more helpful.

Drain the oil and put fresh stuff in, check the air filters, change the oil filters and fuel filters. Look for sand and mud in the oil and fuel filters, dust behind the air filter. Drain the fuel tank and examine the bottom for crud. If all that is good, then it probably never went to the...

The 9000 but/h A/C I have does have a heat strip in it, and it's single phase 110v. Almost all of them use R-22 refrigerant, which is being phased out. Because of that, a 30 pound jug has gone from $60 to about $180 locally, and can only be purchased by a licensed HVAC specialist. Since most...

It has all new vinyl 'canvas', the four inch griddle, looks like all the poles and ladders, some of the new food containers. Even so, I don't think I would have gone over $3400, including the GL fees. As for the ones in the sandbox, many may come home, as we are 'supposed' to be drawing down...

Daniel, If you get to the San Diego area, try to stop in to Murphy's Surplus Warehouse in El Cajon. GPS 32.799448, -116.970803, 300 block of North Johnson Ave. Not a lot of green stuff there but lots of electronics.

As was previously said, use an MP-68 base instead of the AS-1729/VRC, and then use a combination of the MS-116, -117, and -118 antenna sections to achieve the total length of 110 inches. Manually set the MP-68 base down as close to the CB frequency as possible (30-33 Mhz is about as low as it...

KK, Yes, all CFC's must be removed before they are sold. it's done either by the unit, or by DRMO before GL can touch them. See 40 CFR 82.156(f) for details.

Bjorn, You forget about the Steelsoldiers supply line! While not much crosses the Rocky Mountains, there are bold folks that make long distance trips east and west. You just need to find someone doing so (or having a deuce sized veh shipped east - say from Idaho Motor Pool) that the head...

KK, The S-280 tie down brackets are available from Ontario Surplus. A couple of years ago, they were $30 plus shipping for a pair. Do a search for Ontario Surplus here on SS to find their contact info.

Wreckerman and SCSG-G4 were the main cooks, with lots of help and adult supervision by Monica, Bama-Lady, and Ms Pam, amongst others. That MKT is owned by SCSG-G4.

The long cabinet storage space has one section (where the MBU Inverter is) that is setup for the cookie sheets as a cooling rack that will hold over half a dozen sheets. It also works as a 'flyproof' storage area for bread. 3dA, you need to come to the GA Rally in Oct (19-23) and see an MKT in...

PM Sent vtdeucedriver

Tony, I personally have a harder time finding things in the Classifieds than I do using the 'search' function. Maybe it's time we simply did away with the Classifieds and let e-bay handle it all! Easier on the moderators, far fewer posts to wade through for the rest of us, fewer cry-babies...

Here's a pic of the one w/o the bed, taken at the hanger last year.

Travo is taking some stuff to Louisa, VA at the moment. I'll look and see if I have any old pictures of the babies when they were at the hanger.

Using the Military Issue dual brake system, properly installed, will remove most, if not all of the liability for modifying the brakes, and make a safer vehicle to boot!

I'm using a Marinco 30 amp in mine (see 'a different M108 conversion' for pics). Looks like they wanted three phase power in your box, probably for a motor. Two wire is usually just regular 110v.

3d, The -206-13 and the -206-23P are both on the MKT Thumb Drive that I've put together. The -13 is in the TM section here on SS (if it ever is available again).

Their web site is > Antique Books - Rare Books - Ephemera For Sale in St. Augustine Florida They show at least eight catalogs of manuals that can be ordered on-line.

Looks a lot like the PTO shaft we removed from a deuce a couple of weeks ago. Exactly how long is it?