Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
Microsoft MSN, Live, Hotmail, Outlook email users may not be receiving emails. We are working to resolve this issue. Please add support@steelsoldiers.com to your trusted contacts.
i am not positive but i think the latest cucv types are dodges, my wife almost got run over by one near fort eustis she said it was od green had huge brush guard wrapped around the front of it and it was the meanest looking truck she has seen
my stepson has a civy model 86 4x4 that is currently in pieces , if you would like i can try and take pics of his dual tank set up and and send em to you i was scoping it out the other day while removing his t case and it does not look real complicated to add another tank i might do it to my...
just to keep it simple make sure no glowplug wires are grounding friend of mine had that issue this week with the smoking resistor, it turned out to be a stupid wire
I finally got a new steering knuckle, after i trashed the other due to some awful ideas and a bad drill and tap job. replaced all the king pin bushings and then finally got to drive my truck home from work for the first time in about a week :D
yesterday morning pulling into work i suddenly heard three distinct pops coming from under the truck and steering went away. i stopped to crawl around underneath and find three of the 5 inch 1/2 20 studs holding the steering lift block thing snapped off inside my steering knuckle. i then...
I decided to replace fluid and filter today however i noticed the filter is not rigidly held in place by the bolt and spacer and just sort of hangs there on it, is this correct? reason i ask is it seems the filter is leaving wear spots on the pan bottom and the filter is sort of loose however...
I have wellmans in my truck they work fine as far as i can tell however they will swell. i just helped a buddy pull his wellmans yesterday and most of his were swollen it is said the ac 60s are better. i have been searching threads all morning and not coming up with any conclusive brand being...
well it seems the picture thing is beyond my current technical prowess i will keep after it. the basic description is : from the exhaust manifolds to just past the transfer case is 2.5 pipes (dual) to a dual 2.5 inlet to 3 single outlet 14 inch jones muffler then down drivers side over the...
I am sure this has probably been said a few times on this forum. however i just had a new exhaust set up installed yesterday 2.5 pipe from manifolds to muffler duel inlet to 3 inch outlet and i was simply amazed in the noticable improved acceleration and responsivness of my truck. no wheel...
vacuum lines and modulator have been replaced as well as alll metal lines cleaned out with air pressure and carb cleaner truck hits shift points about right and it jerks very slightly so i think i have it dialed in. i was more just curious if adjustment of the vacuum valve (what i thought was...
ahh no wonder i could not find it. not sure i need a new one yet but it was the one thing i could not find any info on so therefore could not check its operation and its been bothering me. thank you for the info much appreciated.
i have been searching for a procedure that explains how to set the throttle position sensor on the side of the ip however i cannot seem to locate a reference to it in the tms or haynes manuals either the diesel manual or the chevy truck manual. does anyone have a clue where to find the...
I am really not sure yet i will probably replace what is there soon as i can so i am sure about what is in it and when it was done last. Any recommendations on what would be better the wellmans or the ac's?
i have a manual glow plug set up from a previous owner, as well as quite a few modifications to the truck in general i am still seeking them all out . up till a few days ago the glowplug card was fine and i think all it did was operate the wait light circuit. well i was driving to work and the...