Search results

Same guy, different CL ad. military surplus close out If he was closer, I'd go take a look....

http://www.steelsoldiers.com/members-rides/37391-wifes-mv-its-yellow.html

Yep. I'll entertain all offers over 12K for my (PERFECT) M1010 with less than 7000 miles. Did I mention its perfect?

Are there electric sites still available? If so, my M109 is prepped and ready. Otherwise, I may rethink the vehicle choice....

Shawn, Line-X goes on via high pressure and must be sprayed by a licensed franchisee. It is not ideal for interior projects, but is ( IMO ) unsurpassed for exterior bed lining projects. For interior projects, I've used the Rustoleum and Plastikote bed liner products. I prefer the Plastikote...

Not sure what it is for, but when redoing the inside on these trucks I cut it out.

Low air pressure in one tire may make a similar noise during turns. Might be worth checking to rule out an easy fix. I had a bad rim on my '08 and it was leaking air real slow. When under pressure by 10lbs it would skip during turns which sounded like a pop.

I've recently noticed the same issue with my '08. Seems to be the driver side front that hops. I'm going to tear down the front end this coming week to resolve. Anyone else have any updates on their progress resolving?

Check the regulators on both alts. Just be careful when you reinstall them as the metal prongs can push the metal sleeves into the housing on the alt if your off center. In which case, you'll need to take it apart to reseat the metal sleeves. I believe my two are at the middle position. You...

Any issues with the lights hitting the ground during the tilt? it is hard to tell from the photo, but it looks close. I have two M101s I need to recover and your idea may just be the way I do it.

Someone needs to figure out how to get the signal from the tach buffer which is used in the diagnostic system. The STE-ICE could tell you the RPMs, so there is a signal there that just needs to be tapped.

Doug's prices are not too bad considering what the setup would cost the owner of a single truck. To get the controller, cable kit/software, etc will cost ~600 However, if I was offering the solution for sale I would disclose the actual hardware being used and sell my wiring diagrams and...

Is the duvac removed? How did you rewire the top alternator?

Yes indeed, since Woodward makes the APEC 4500. Clearly this is the device in the OPs 1st post.

The alternate is the APEC 4500 which is made by Woodward as being discussed in an alternate thread.

The PTO set is rated at 12KW.

As requested.

http://www.woodward.com/engine/diesel/diesel2/electronic.cf Same page pretty much.... APECS 4500 is 5th from the bottom.

Is that unit a Woodward APECS 4500? Electronic Controls & Software for Gas Engines

Also, it is not uncommon for the equalizer to run for a period of time to "equalize" the charge. This is normal. But do make sure to keep that master light switch off when not in use. Otherwise, you will drain your batteries. EDIT: led ON = 12v draw So, either your front battery is...