Search results

If the temp sensor is high in resistance (open when its disconnected) during the start up sequence, the GP module will leave the wait light on for the maximum amount of time. As the sensor warms up the resistance lowers and the wait light will not stay on as long. It would be best to have a...

Try using emory cloth over the tip of a small straight blade screw driver. 100 grit should work. Karl

Yes, the LED indicates when the GP relay should be closed.

Attached is an explanation of how the CUCV glow plug module works. And a visual one as well. http://www.youtube.com/watch?v=MTkOl947aTk&context=C31745e9ADOEgsToPDskKZSH-k5s1Vkq4YraUvB2L_ Karl

Yes I did.

You need a card that looks like this one. Karl

Welcome to the site. It sounds as if your lift pump is bad. I did the exact same test that you did with the same results. This test proved that my newly installed lift pump was defective out of the box. Installed a second new lift pump and had good fuel flow to the filter. After a little...

This may help you. Karl

It could be that the monitor voltage to the glow plug card is not as high as it was prior to changing the glow plugs. A properly functioning glow plug card will beging to cycle the power to the glow plugs as the voltages increases on the glow plug side of the relay. As the voltage increases on...

We use 3 of the AB-577 type masts for Field Day. They work very well. Easy to put up and take down. Karl

Yikes! Very nice collection. Karl

Welcome from Central Pa. Karl

Here ya go. Karl

Yes, you should have continuity to ground if that is the white wire coming from the 4WD indicator switch. You will need to select 4WD to close the switch to ground. Karl

The Wait light is turned on by it's own transistor from the glow plug card. The glow plug relay is turned on by a seperate transistor. Check to see if the glow plug relay is closed the entire time the Wait light is on. Either way, it sounds as if you have a defective card. Karl

I don't own a 1010, however I asked a good friend of mine that restorted his. His reply; "2 Small red cross panels that attach to air conditioning unit are 4"x 4" 2 Side panels that have the cadeceus stencil are 12" x 12" 2 Side large red cross panels are 39" x 39" 2 Rear door red cross panels...

If it's a factory wire, it may be the white wire coming from the 4WD indicator switch. This is the only all white wire that I can find on the F-4 cab ignition circuit schematic. To test it with an ohm meter. Connect one of the leads to ground and the other to the white wire. Shift the transfer...

I bought a DB2-4544 From Orgeon Fuel Injection for my M1009. I do not remember what model pump I removed, but it was not a 4544. http://www.o-f-i.com/index.php?pid=14#INJECTON_PUMP,_6.2L_&_6.5L It works well and I have had no problems. They shipped it right away and I received credit for the...

Welcome from Central PA. Just a friendly warning, you will soon find out that "One is not enough." Karl

Here is how I installed my tags. Angle aluminum held on with beam clamps. And yes, the license plate light was an afterthought. I was told that in PA you don't need a light if the vehicle didn't come with one. But for the $4.50 it cost to install it, I was better off to install one and not get...