Search results

For those of you who are interested in knowing where your tires came from, a listing of DOT codes can be found at: http://www.harriger.com/tires.htm The last four digits of the USDOT Tire Code are the week and year (upgraded from the old three digit week and year code that was used until the...

No, but please take lots of photos of the installation process for both as I'd really like to include your work on my M37 website... I've got some information on it for the artic heater kit (the install manual for the Perfection unit that mounted on the passenger side between the running board...

Last set that I purchased that were not on a parts truck came from Army Surplus Warehouse... http://www.armysurpluswarehouse.com/ I'd also give AB Linn, Sid Beck, and John Bizal a call. A B Linn Inc. M-37, M-715, jeep parts. 7022 Jones Road, Salisbury, NC 28147. 704-637-9076...

Perhaps because the test for a non-CDL Class B is the same as the test for a CDL class B?? Only difference in obtaining either version of the Class B (at least in NC where I am located) is the paperwork (gotta have a medical card or an appropriate exemption if CDL). Ditto for a Class A...

Re: RE: April trailrides in North Carolina (Uwharrie OHV) I don't think that they have an online presence yet... :( Prices aren't bad, but I think that the prices for stuff in the back (not in the showroom) are partially dependent on the weather, time of day, and how well they know you... :)...

You may also want to post your add on the Gama Goat website... http://gamagoat.com/ Good looking vehicle, hope you find it a good home.

Agri-Supply and Tractor Supply cary it in five gallon buckets in my area with a choice of four brands or so each... Way less expensive then GL5, but they both have gone way up in price in the last couple of years... :(

Nice job Bryan. :) I really do have to stopy by your place nextime I'm in Black Forest visiting my niece and nephew... I like that tailgate too... You make it beafy enough to serve as a bench/table when out in the woods?

If you are talking about the bolts that attach the axle flange to the hub (six of them per side), they aren't actually supposed to be bolts but are actually supposed to be studs... I have noticed on more than one M37 that I've worked on that the studs have been replace, in whole or part, with...

I run with the stock housing with goat lenses and have replaced the bulbs with LED replacements... If you swap the original style round lights (both the three bulb or the two bulb variety) for a modern composit, you will have to redrill the mounting holes about a half inch lower on the...

John Winslow: Dealer located in Halifax, NC (northeastern part of the state). Does not have a website that I am aware of. I've PM'ed his phone number to you...

RE: Re: RE: Trailer buying advice needed Both the M101 and M101A1 3/4 ton trailers weigh in (according to the dataplates on mine): 1340 lbs empty, 2840 lbs cross country (including payload), and 3590 lbs highway (including payload). Lunette ring is 21" above the ground. Wheels are 16x6.5H...

The NCANG has just about finished turning in their CUCV's... They had been running large quantities of them through Bragg and LeJeune over the past year. A whole lot of them went through the FEPP site in Raleigh and was distribited to such users as VFD's (which have been turning in their old...

Thanks. I sent you a PM with a little more details of my recent contact with Bruce along with a request for assistance with the convoy again this year. I hope (and am pushing) to have the website in operation sooner, and to recapture some of the historical info that has been lost. I really...

Bruce has asked me to take over the Convoy since he 1) sold his deuce, 2) isn't sure if he is going to Aberdeen this year, and 3) figured that I had been effectively running it for some time....

Thanks Mike. I'm leary of pulling it with a load very far without one...

RE: Re: RE: Re: RE: East Coast Convoy 2008 I'll actually will be posting blurbs on six or so forums that are frequented by folks who I know have participated in the ECC in the past, but the majority of participants are on this site... I've been talking to the folks who have been working on...

Tire size on the M796A1 bolster trailers at Bragg is 12x16.5 on a six lug rim that looks to have a 9" bolt center (assuming that I remembered correctly how to measure a six lug pattern... ). As Mike Pop says, they are the same as on the M1061 trailer, and I am in the market for one wheel/tire...

In North Carolina, the military units that have been transporting extra-dimensional loads have been following the provisions in the State's regulations with the exception of spacing of vehicles (military does convoy while civilian extra-dimensional is not allowed to do so). I think that it...

Re: Towing That picture looks oddly familiar... :) Since this photo was taken, I have been informed by the owner of the M816 that my M37 is hooked up to that, according the TM, he has the hook attached to the wiffle tree incorrectly... I'll let him explain if he feels so inclined... We...