Search results

Opening the TM 9-2320-289-20P parts manual and searching for "bracket" I found diagram #152 in under 5 seconds. I for one have also never seen this bracket, but now I also know what it is. Who ever had the truck previously had used the blue flame wrench to remove most of the bracket

The CUCV TMs have the following: Introduction Table of Contents Appendix Glossary Alphabetical Index and foldouts in the paper versions. The electronic versions are in PDF format and searchable. All my Chilton manuals are paper and I have to physically search. The TMs I just type and click. I...

One of the easiest ways to find a part name, part numbers or how something goes together is to find the set of tech manuals for your vehicle, open up the parts manual and scan through the pictures until you find what you are looking for. I can't tell you how many times this has helped me when...

So what is inside the unit? Compressor? Welder? Genny? Any more pictures. Thanks for updating your profile.

The plug in the second picture is a diode for the "water-in-fuel" circuit. It does not plug into anything. Now that you have had it running and know that it does work, we will work on some of the other systems. How is the parts supply for American vehicles? Can you get everyday items like...

So what was your solution for your recovery? Did you fly? Drive? Have someone pick you up? Always good to close out a thread. http://www.steelsoldiers.com/showthread.php?127470-Help-with-ideas-for-picking-up-my-newly-purchased-M923a2 Glad your trip was uneventful. Good looking truck.

Looks like an old Lincoln Welder setup. Looks like storage boxes where added to the sides. And please edit your user profile. Your state of residence is required. The US isn't a state. ;-)

:funny:

Read all the Helpful Threads for the CUCVs. Besides the Starter Relay upgrade there are a few other items to checkout. There is even a how to for the fusible links that you may now have to replace. http://www.steelsoldiers.com/showthread.php?123199-CUCV-helpful-threads

Welcome from Oklahoma. Please edit your profile to include your State of residence (site requirement). We do not use image coding here. Read this thread. http://www.steelsoldiers.com/showthread.php?59917-How-to-post-pictures-a-tutorial

Straight from Rapco's webpage http://www.rapcoparts.com/manuals.html PAINT THINNING RECOMMENDATION Thinning ratio for paint & primer is 4 parts paint or primer & 1 part thinner. Most of our customers prefer XYLENE. If you have a Gallon of paint or primer that has set for some time, you will...

The low coolant card is next to the fuse box. The STE/ICS connector is the round cannon plug below the dash. The two cards near the starter relay are the STE/ICE Tac Buffer and Resistor cards. They are not used for anything except when using the STE/ICE diagnostic unit. Most people have never...

What turbo did you install? Banks? GM 6.5L?

Yes they are both suppose to light up. The above steps are a good place to start. Also the TMs have some good troubleshooting.

Bump for the people who still haven't read this thread

Looks great. Very similar to K9Vic's Suburban CUCV Clone snorkle setup. Post #90 http://www.steelsoldiers.com/showthread.php?106784-My-1984-Chevrolet-Suburban-K20-4x4-3-4-ton-CUCV-clone-2-AKA-M1007-or-M1029

Here is the diagram for the coolant sensors. They are listed in the TM 9-2320-289-34P manual, diagram #54. The Fast Idle switch is item #2. If you are looking for a part, skim through the parts manual to find the picture and the part number will be listed. The original GM part number is...

http://www.steelsoldiers.com/showthread.php?127720-HELP-!!!-JATonka-needs-help-Broke-down-in-Pa

Freeze plug issues usually don't show up during PMs. Wish I was closer to help. Looks like he is about 40 Miles from Harrisburg, PA. and 35 miles from Coleman's Surplus. in Millersburg, PA http://mapq.st/USP4p6 For those tha haven't been following JaTonka's trip, he is driving the his...

Changed title and made a sticky