Search results

Went to a close friend's house to help with a MEP-003a starting problem today and, after fixing, noticed that his electrician had sunk and connected to a ground rod, maintained neutral connection at the frame of both units and ran 3 wires to his panel at the house using an interlock kit on each...

"my tire shop said they are high speed" Take them back!

Bill, If still no fire after reassembling, I hope the worst you will find is an undetected air leak. Jerry

Pulling a tank is pretty simple (unless you have an ASK). I am impressed with your ingenuity but wonder how much work you saved. Jerry :beer:

Bill, You really need to get into the TMs. You don't pull any spring to time the IP, just a little access screw on the IP base. put the base of a 1/8" drill bit in the hole and turn the face gear of the pump until the bit drops into a key grove. Keep the bit in place...

Will exchange spring when I reassemble the pump. Jerry

Update, If anyone sees something I missed, please chime in. I pulled the IP apart today. A lot of trash in it and the plunger was jammed a bit but not enough to keep it from working in my opinion. Good news is no broken parts. Have asked Bill send the injectors back to me...

Mississippi, Louisiana, Texas.....sounds like a marriage made in heaven. Certainly closer than Canada. Jerry :beer:

Overcome by events

Update: Bill has gone back to school full time and has opted to send the IP here. The Flea Market was open this weekend, so all I got was a call tag in my PO box on Saturday after we closed the store. Will pick up on Monday and get back to ya'll with what I find shortly thereafter (while at...

Try this fellow. If I understood him correctly, He has parts that may help you. "mpontiff@essicorp.com" Jerry

Silverbullet, BTW: Good luck on your machining project. I hope it works and holds up under extended loads. Jerry:beer:

Silver bullet, You need to go to the TM and read the timing section. The index you use is the pointer over an open hole just below and to the left of the IP. It lines up with PC marks on the flywheel (versus fan). Rotate carefully until lined up with PC center mark then install IP. Go only...

To clarify where we are: From Bill: Just finished pulling the pump. Model # M50 2/4A-80A-9540A SER BE 56948 I have the AMBAC exploded view with parts ID info. Not sure what issue I am looking for, but know that there are...

Grant, Are you talking the actual flywheel between engine and generator head or the fan at opposite end? Jerry

What a great introduction for a potential member posting his first. Welcome tmaca Jerry

Bill, Most important thing is to record model number once removed and it will help ID likely problems. If you prefer, E-mail me when you get it off and I'll try to help you. Jerry

Sorry Munchies, I have the pin and the shaft but the rectangular end of my pin is awol. Jerry

The connectors are the same and I have used ones, as likely, does Gimpyrobb. Jerry

Munch, I'll look around. Jerry