Search results

12.5R20 XL's are the same diameter as the 900-20's (unsure if those can be used in a dual rear setup though) picture is eleven - 1100R20 XL's on stock rims

I've been getting mine from the Dodge dealer.

a sprag TC on a 1987 ??????????????

It is rare that someone attemping to sell something doesn't try to sound like a heck of a guy on the phone. I never trust a salesman when his lips are moving.

sounds alot better than a bent driveshaft & crushed exhaust from the typical hilo crap. drag link and /or tie rods for what is probably one of the most common vehicles on the road in this country. are not very expensive or hard to replace. Sure GL should know that their bubba is a moron, but...

Here in Michigan, My 16,000lb M36A2 is not restricted by the MDOT frost laws. The most weight is on the two front tires, yet it is still within the frost law limits. The limits are tighter on the steering axle due to the forces generated when turning corners. on another note, my pad in front...

Yup, M886 Truck Ambulance 1 1/4 ton extra poor fuel economy??????????????????? My M886 got 36 MP4G (miles per 4 gallons) Where as my current (Ex Air Force) Ambulance gets 32 MP4G

well when I read the title I was thinking of the axle shaft retaining nuts, not the lug or bearing nuts............ oh well.

Ok, you found it, you got 1st dibs on it. I don't need it. but if you don't buy it quick, I might be headed to Columbus soon..... M888 = rare find also worth noting it is not a 1978, it is a 1977 it is not a D200, it is a W200

Radial Tires require radial tubes, use the size recommended for the tire regardless of rim size.

Here, posted with less effort than whining about it.

All the info needed to bob a deuce is right here in this forum. both the right way and wrong way, and a few grey areas too

Nice, Thanks for posting the details! Now to adjust those rear brakes :wink:

The Data plate is next to that white sticker on the lower steel portion of the dash. That interior shot does indicate that it is a M880 series truck. Which one should be stamped on the Data plate. m880 series trucks were 76 & 77 models year Dodge powerwagons. Dodge had not yet come up with the...

Lot's of good advise above. My limited experience says your issue was a Deuce with singles pulling one with duals. You might see an improvement if you were to pull the outside rears on the towed truck.

M36A2C ????????? I have a M36A2, what is the "C" version? Never heard of that, Is that with both sides drop like the M35A2C? I found this listed in TB 9-2300-280-30 M36, M36A1 , M36A2, M36A2C, M36C. attached pic of early M36 (notice no drop side). Also my wallet is thankful that the NOS M36A2...

Same reason 7-11 sells things at twice the price Walmart does. Convenience & service. I don't hold it against him, being frugal (ok, a cheapskate) I searched the world wide web for the best deal. That took time and effort, time is money they say.

commercial is the key word commercial tractor, truck.............. check with a lawyer 1st but that comma between tractor & truck connects truck with commercial. A guys toy is not a commercial vehicle. you should be good to go unless somewhere else it restricts the amount of axles.

I just got back in from under the truck, outside Michigan winter! Anyway, I have still not been able to find anything in print about the the tow bar adapters. That's why I was just under the truck. It has been said before that the adapter plates are for the M890. Don't have one of those, but the...

Not sure if the UOC means was used on or could have been used on. but the M884 is listed under skid plate and sway bar. As for the adapter plates, if they were for the 2wd drive aka M890, why do they say M880 Adapters on them? Istill have not found anything in print on them. Slow to fill - mud...