Search results

I've been looking into getting a nice canvas seat cover made for my bench, much easier on the legs than 140F vinyl

well after many years of use, the boxes do loosen up, there are instructions to properly set them back to factory specs, if done wrong you can wreck the box. I have the directions on how to do it, but will have to scan them into the computer as right now they are large jpeg files. and the...

I merged the two topics together

I've sent you two PM's would like to get some of the resistors from you, or at least the company that you got them from. Please respond when you get this.

i am still leaning to a issue withing the steering box, but simply marking the location of the leaf springs and then backing up until you get the steering wheel out of center and looking at the marks will decide if the springs are the issue. I dont think they are though. since you would...

the XL's or XML's? I'll have to let my uncle know.

with hearing a click your solenoid should be good. are you getting fuel to the filter? from the filter to the pump? you have air in the system somewhere, the fun is getting it out.

if the controller is missin, I reccomend just adding a manual switch until you decide if you want to track one down or not, i use the manual switch only in my truck, works every time.

RE: New Type Jack Available for the HMMWV that is not an effecient jack for a lifted cucv, a blazer maybe. but that thing wont even touch my axle at its max lift, let alone get the tire off the ground.

the easiest way would be to just put a resistor on the sense wire, like the civilian apps used. so even without the light working there will be enough draw to start it charging.

http://www.dieselcare.net/CHEVROLETPRODUCTS.html check out near the bottom of the page. send them an email to be sure you get the right one, but looks to be $50

be sure to use the "profile" link at the top of the page. you should be able to edit your signature there. If you can't respond to this thread and give Mangus580 some time to look at it.

havent been able to get to the extra 10bolt axle i have yet, but supposed to be going out there tomorrow.

and my Gen 1 light has not worked since i've owned the truck, but it still charges, so i dont worry about it.

left? please use drivers or passengers, makes it much easier.

Bad fuel shutoff soloniod. yup, that would do it.

those look like they are from USA6x6

I fixed your title.

USE DOT5 FLUID ONLY, if there is any original fluid left and you use other it will give you all kinds of grief. BE VERY CAREFUL not to get anything into the IP when removeing the studs. worst case i have a spare engine i can rob one off of for you. and the "cut off" as you put it is the...

since the back issues of MVM are on there site now, can someone just post the issue that the article is in. then everyone can go to the magazine site a look at it.