Search results

to tell the truth this sounds like the main power selenoid, mine sticks every now and then, if no gages ,ect come up when the main on/off switch is fliped, i flip the switch a few times and it is ok,, not sure if its all in the pcb or seperate

RE: Re: m811 on gl i found out about the xm977 that went up on ebay from a SS post,i did a buy it now knowing that others were looking at it, in fact at least two were SSers who i have talked to later,thay both gave me [thumbzup] on getting it, even though thay wanted it, also there was a...

go to tips in the fourm, there is a resize gismo there

if im steping on somebodys toes on this im sorry, but this to nice not to pass on, a m811( shop equipment org.) at camp blanding fl., heres the link http://www.govliquidation.com/auction/endecaSearch?Ntt=m811&Ntk=P_Lot_Title&Ntx=mode+matchall&N=0&Nty=1&Ns=Lot%20Number|0&words=m811&cmd=keyword

i have seen pics of the cover on with just the end of the trolley beam and supports sticking out

a xm757 SURE would look good parked between the 819 and the xm977(xm983)

if you want to stay mulitary instead of that red looking thing, :lol: you could go with the ammo loading kit that fits in the bed, it fits under the cargo cover, has a chain fall that rides on a overhead rail, i beleave there is a tm on it in the tm section, i have seen them come up on gl from...

did you DID turn the buyer on to SS didnt you

i brought a compleat new horn, selenoid and all off ebay for about 15, used my old selenoid on a 152 db horn that i had

in Crismom's US military wheeled vehicles (page 398, top, left) it states 25000,thats compleat with k boom and bed, so without the bed and crane, i beleave 16000 would be close

it can be towbared

since i didnt make it to aberdeen with the 819 and then tow the 977 back, im starting to look for a lowbed to bring it down for a reasonable rate, I need to bring it from romney wv. to gainesville, ga., thats about 600 mles, the weight is about 16000, a lowbed is needed because of the 11'...

i found a m37 in houma la., its at consolidated truck salvage, 985-879-3554, this truck is a rust bucket but is compleat, was told that it ran well when it came in (ive heard that before), its located at 4864 highway 182, the owner said he wants 600 :lol: i bet he would take a lot less ,cash talks

i just replaced that seal, the seal i used that crosses with the mil. numbers is a SKF seal number 58741 , the speedy -sleave if you need it (if the seal serface is to badly corrorded) is chirago rawhide -- cr 99587 the hard part will be getting the winch on the ground, mine was already on...

dan, i need the crane weight lift chart data plate for the 819, thanks ,ron

if one is bad, check all the rest, if a top one breaks, the axle will roll, takeout the driveshaft and brakes, when i went to replace mine on the 819, the front axle rolled 4" just turning the truck around, not enough to do damage, but if it would have happened on the road doing 60, it would not...

if this all works out, we are going to have about 8 or 9 vehicles just in the south, south convoy, that alone will be a nice looking military movement, we all need a SS unit designator, that will really make us a single unit movement instead just a bunch of military trucks

RE: crane plate i also need that plate

you know deep down inside that you DONT want to sell it

i hope to camp, rough it, or any other turm you want to use