Search results

Personally, I like to use a large soldering iron(not a torch). If you must use a propane torch, I would get/use a soldering iron type tip, so you are NOT using the flame. You need acid core and flux, found in the plumbing dept. Gently clean the surrounding area and tin the edge of the...

Bad wheel bearings would also possibly cause loss of brake pedal. I think Ron is on the right track.

I did not notice anywhere in this thread, it mention the relay needs to have an isolated ground on the coil. The pictures of his relay, have me slightly concerned that, that may not be the correct relay. I suggest you test it before you use a GP controller card(or you could damage it).

The 12V terminal(stud) and the wiring and fusible link feeding it, is adequate for the task(supplying the GP relay with 12v). Many of us have done this, with no problems(long term). btw, your thoughts on load on the bats is incorrect. But we don't need to go there.

There is a relay(on the engine block) and a solenoid on the starter, that could cause your issue. You need to use a meter and test for voltage along the starting circuit, to find the problem.

I open my picture in Microsoft Paint to insert text. Then save it, then post it.

There are adjustments. Proper window adjustment is completely covered in TM9-2320-361-20. Chapter 11, paragraph 6.

As long as the slave cable stays connected, the alternator will be ok. As for the cranking issue, sounds like a bad connection or cable.

Sure. Maybe I can eat too fast and choke for real, on a piece of WM's all dark meat 4 legged "chicken".

Carnac, maybe we could take 30 minutes at the GA rally and give a demonstration of proper technique for CPR and the Heimlich maneuver. Not a lesson, a demonstration.

Retail is for sissys! 2cents

I called today to try to schedule a pickup at a GL location. The number is not in service! I contacted GL at Arizona and they said they would get back to me when they have a phone number that works. I will say, the 2 calls to GL today were both handled very very politely and friendly. I...

Does the Hmmwv use the same flex plate?

14077157 - GM FLYWHEEL

If you click on "customer reviews" on the website for that part you'll see this.

What brand and part number did they give you?

Post#4 in this thread. http://www.steelsoldiers.com/deuce/72297-tm-numbers-clutch-change-requested.html and a bit more info in this thread, post#7. http://www.steelsoldiers.com/deuce/74262-stuck-oil-drain-plug.html

Spoiler, hahahahha... my wife calls ricerocket spoilers, fins! You gonna go with 12 or 24 volt?

a bit more, The OP has been a member here for almost 8 months. He joined this site with the intention of buying an M35a2. 8 months, and he doesn't even have the TMs. What does this say? As for the hard to find and many levels of TMs, there are 3 levels, and if you ask, it's easy to learn...

Nobody's head was bitten off. And for you guys that just want to cry first, and tell me how to be gentle and helpful, well I answered his question, I also posted the TM page with the information, and I emphasized the fact that he needs to use something other than a phone and get the TMs...