Search results

I know I am not supposed to, so before any one say any thing, So please forgive me. I do not know the seller and will not benefit in any way. But for a couple of years people keep asking, what works to cut down the decibel noise level inside the CUCV cabins, my solution an OEM HD rubber matt...

I need to confirm parts so I can order, pick up upon my return and finish some R. & R. to my drive line. After doing some research here and else were...I am confused is the front drive shaft "U" joint to the D60 pinion just a 1310 ? is the rear drive shaft to the M1008- GM14 bolts, a 1410 or...

What direction should the center Chevron "V" on a HMMWV radial 37" be, when looking at the tire from the front? The reason I ask is, because when I mounted the 37" to replace the byasply 36", I started on the right side and took notice of the direction to be pointing UP like a tractor tire. I...

Just wondering:cookoo: Has any one gone the Bob-job on a CUCV truck route, using a M35 bed with the drop sides/tailgate? They look built for abuse... Looking around I found an Avatar with a CUCV pick up bed on a M900 ? I imagine that it is probably needs to mount higher above the rails...

Can someone help me identifier this snow chains? I was told they were for a Humvee Thank You.

Any one "on line" well verse with the CUCV starting system, that I can talk to about the CUCV 24v. resistor? Please send private message so that I can CALL you right back live

Hello, The extreme cold weather here in the Mid-Atlantic have manifested itself. My M1008 cranks but will not start, with out the use of either after disconecting the GP'S. Engine block heater plug IN, winter fuel additive, New Batteries, GP's, GP controler card, GP solenoid, GP temperature...

My # 2 alternator went bad (hard starting and dash volt gauge in the low side and "NO" #2 alt light), I had both alternator bench tested at an electric motor rebuilder place; #1 was OK and putting out 14+ volts, I had both alternators rebuilt to new specs: Delco #1100500 -12v. with isolated...

Hello. Can some tell me what to check or R/R? She goes true the starting cycle and starts fine but my WAIT light comes on, and will turns off after 10-15 sec. or so even after the M1008 is up to temperature? I am not sure wich convination sensor/switch to check? Thanks

Hello. Could some one with a stock hight M1008, Please meassure the distance between the 2 pivot points (top to botton) on the rear load proportioning brake valve dog leg. Tha bracket I spot welded to make up for my lift kit, fell off and I can't remenber (5 years since) the meassurment, to...

Hello. I have being using this new page for a few weeks now so I am stll learning my way around. I was wondering if there is a section were you find all other membesr photo/ images, as in the Old site. Thanks