Search results

I been reading past posts and TM ,cant seem to find anser when pressing in or out torque rod ends , dose it make a difference witch side pressed from ( any lip on torque rod ) Thanks Harry

I should have taken some before pics was caved in about 3" water pooled on top. took out all inside (supports most were cut for man hole ), grined off what was left , fliped over and worked out, fiberglassed a sheet of cabnet 3/4 ply wood should be able to stand on top with out caving in...

Im not sure what they call these boxes but sure make a great sauna when weather warms up will camo outside

a few pics before and after still going to repaint inside of cab and re letter truck redid troop seats and head board (used composit decking ) slplit and rouned edges over Harry

any one know if they make a nato cable adaptor (old style 2 pin) I want to be able to use my old style( 2 pin )cable on new style 1 pin receptacal (female) the adaptor would have two hole female on one side and 1pin male on other end Harry

Have a M35a3 their is intermittent wobble in frount end above 40mph . tightened link ends , tie rod ends are tight . using a tape meauser i measured tires and their is no toe in measured M35a2 their is 1/4" toe in no wobble (drives fine) , could toe in cause a front end (...

I get this wobble that comes and goies it happens at speed 45+ feels like truck is moving side to side can feel it in sreering wheel but dont think it coming from front tires ,if I slow down a bit and speed up again its ok for a wile , you think could be when rear tires get in a certian...

Any one know if theri should be front running lights on a 1968 M35a2 all of my other lights work , their in no front amber lights , ecpet when blinkers are blinking , would be the top bulb in light bucket thats not lighting thanks for any help Harry

Hello Looking for 1 M35A3 wheel counter balance weight a friend pointed out that I am missing one on rear wheel maybe that caused some of the rear bounce ? Thanks Harry

looking for tach sensor part #EX2547 for a 1990 M35A3 I cant find a cross refrence number any one have any information??? Harry

tach stoped working looks like has sensor on bell housing is their a way to test? I hooked up a meter with engine running and off no change (was open) ,

I did first 500 mile trip , it was bouncy ,at times ,might add tapered shims under front of bed Ran in to a few glitches Tack is actting up was reading wright then started reading 500 rmp when should read 2500 , its electricly run not cable . lost air assist on steering Seemed like dint...

Hi never done this before Any tips for changing out the O ring that seals the two halfs on a two piece weel ? Thanks Harry

I have a weel on M35a3 ( two piece weel ) has a slow air leak. Its not the CTIS . looks like leaking between weel halfs , sprayed some soap were filler pipe goies thur weel and was bubbling in around gap . Is their a big o ring that goies between the weel halfs and dose any one know were I can...

I have few questions picked up M35a3 has ring legs cab reinforcement ect . no ring any one know what I would need to mount ( is theit brackets on the ring that bolts to legs? ) and any one have a reasnable priced ring for sale around WI ,MN ? few picks of truck thanks...