Recent content by wilogger

Plus i'm a Wisconsin logger, we do seem to have the same interests lol.

Oh ya i have Airedales and that Heideterrier (kind of) also. Anyway do you have the welder/generator set up in your 1031?

Hi Swamp rooster, I just commented on your nice truck on the Airedale board, i didn't know you were on here to, anyway again nice truck.

Good deal Al, you put a lot of well spent time into it. I have the same welder, i hope to get it going again, then get a contact box to put on my cucv, if i can find one close enough. You got a nice truck.

Nice job!

Yes take the inspection plate off and look, mine did that it just pulled freely, a rod simply came undone, a clip or pin came out of the end.

I hope it isn't your rear end? Mine did that once while plowing snow (Briefly locked) then i got half way home and a gear busted threw my pumpkin! Check for metal in the gear lube 4sure, I hope it's a brake.

Nice job truepumper! Those pics got me wanting to get my winch mounted, thanks for the pics.

Police need to have "probable cause" to stop you, like no seat belt, fail to signal, thats my understanding. My M1008 had red dyed fuel in it when I bought it, I got rid of the fuel right away, it's not worth it.

My bud was driving a pickup, he was stopped for not wearing a seatbelt, then they dipped his tank, saw a tint of red in it, thats how it started.

I think he called it a fuel tax penalty.

Update, my friend got 2 fines one from the Feds, one from the state both around a $1000.00, plus an Audit, that was a real pain days of paperwork.

Thanks, Those bad glow plugs can be a pain to get out. You have to pry them straight, best to get the puller tool thats made for the job. I'm going to run the 2 wires off the controller to a toggle switch in the cab, then I don't have to worry about the controller going bad and swelling the ends...

Tell him good job! Kids are funny and a joy, they sure grow up quick though, soon he'll want your M35 lol.

The original motor in the truck had a broke off glow plug when i purchased it, and it broke free from the piston, where it was fused, and cracked the block a few hours after getting it going. The new motor has 8,000 miles, but needed TLC. New front crank and rear seal, intake, valve cover...