Search results

Sounds like a bare wire grounding out some where

Looks good . Great job

They get warm on all of my trucks.

I agree - the flat one gives you more ground clearance , also more room for dual exhaust but i think the newer style -85 thur 91 has a shorter/stronger t case adapter

Yes 205 and the 208 /241 use the same crossmember provided you use the correct t case adapter. With the 85 thru 91 models they used a w shaped crossmember and they had a zigzag shaped crossmember - the difference being trucks with a diesel engine - had true dual exhaust and used a little...

All chevy 4x4 trucks from 1973 thru 1984 used the flat type crossmember and tall transfercase adapter. Cucv trucks use the same thru 1987 . Civilian models 1985 thru 1991 use the w shaped or zigzag type crossmember and the hourglass type transfercase adapter.

Front driveshaft problem - either bent ,loose , slip yoke bad or u joint/cv bad on it. Take out the front driveshaft and test drive it:-d

A big block radiator out of a 1988 thru 1991 R/V series will bolt right in . Needs to have a 19inch x 34 inch core. I have these manifolds on 3 of my trucks - they look good , donot leak , and appear stock.i will post more photos in the next couple of days.

Yes have clearance for 2 qt oil filter . Also plan on installing oem oil cooler the large one that goes between the grill and radiator.

Most aftermarket ones are aluminum. Crs would be better

Headers are the oem chevy/gmc 1986 454 truck headers.they are made of stainless steel. They came on all 1986 trucks and rv's with a 454 engine - they last forever and clean up with steel wool. I installed the correct metric pipe plugs where the smog tube holes were. They are short and only...

Here are some photos - still needs wiring harness hooked up ,throttle cable clip, and trans vacuum line. Then its ready to run.

Look on e bay. Get a oem part - they will last longer

I have been slacking but will post some photos as mine is almost ready to crank.it will be running this week. I had to do away with the tbi because the donor motor had a engine fire - wiring harness was damaged badly. I also had to get some adapters/bushings made for the radiator hoses - to...

Junk yard . Bucket seats from a 1981 thru 1991 suburban will work. You will have to weld in a front mounting point on the inside rail on both seat tracks. You can remove these peices from a suburban also.

Drained fuel tank. There is a thread on fitting right behind the passenger front wheel - great spot to plumb fuel line/pump - i had to use electric fuel pump because i installed a 1993 454 engine - mark v - no fuel pump boss on block.

Flex plate is different. Wiring harness should work. I used one out of a 1985 gas truck

Mounts are different. The 1991 model has a one peice mount.

Crossmember will work from 1985 thru 1991 1 ton models with np 205 case. Not to hard to find

They were on ebay not to long ago