Search results

Thanks what leads or location do I check the hz? My meter will do that but I don't know the best place closest to the source to start testing the hz.

So I have a few more questions For Mep002a/3a series gens So finally have all of my gens running strong.. now… How do you determine the speed of the motor? Need to set max and min speeds Does the throttle need to be all the way at full to function right or just so the hz are at the proper...

I will look thanks. Its not moving it at all so I will take a look. Thanks

I cant not find the directions on how to adjust this anywhere. Anyone have any knowledge on how to do this? The part I am talking about is on tm-6115-585-24p page132 figure 41 and is called the “the governor assembly”

Sorry I missed what it was its an mep003a gen. I will have to get pics later when I get home.

I am at the point where I need to re-adjust my injector pump I think. My fuel shut off solenoid will lift but the unit will not start until I life the throttle lever (the thing that the fuel shut off solenoid pushes on) up a bit. I assume this is because it needs to be adjusted. It never moves...

Did you ever order this? what did you use and did it work? I am looking at doing the same thing.

thank i will call them this week!

So I found part number at least the old ones in the manual but can match it to a connector.

Thanks everyone for the help. I will take a look. Finding the part numbers it not easy.

I am looking at extending the 2 connections behind the control box. I want to move the box into my garage. Anyone see a problem with that? Anyone know a place to buy the male and female connectors to do that?

I will look in to it. Thanks everyone. Does the unit have a oil temp sensor I could tap into? If I remember right if it gets to hot it should shut down automatically. If that's correct it has a sensor someplace. Correct me if I am wrong.

I am not finding the diagrams but I am using my phone I will need to look in more detail on a computer. Thanks a lot for the info.

How do you test the shutter assembly on an mep003a/002a?

So to all you ASK owner for the mep003a what are the areas that need to have ventilation holes? I am going to build a small shed around it just like an ASK so I need to make sure I have the right placement of holes for cooling. Detailed pictures would be amazing if anyone can help. Thanks

It is running!!!!!!! No leakscand sounds good!! Thanks for all your help everyone!

The way i see it is i have not run the unit since i took the pump out. I know what tooth it was on when it was taken off. All i did was fix it and placed it back the way it was. If that does not work then i will have to figure out the timing part.

So I am working on it almost done. Will anything happen if it is not timed right? Will it just not work or will i break something?

Ya once i get some good weather i will take it out and see if i can find one at the local store.

So i only had a few min before dark to work on it. My wife had other plans for me today. Tomorrow we are expecting a very big storm so it may have to wait until next week ;(