Search results

Im an hour or so north of Tampa and would be interested in a meet / cruise.

Do you by chance have any specs or part numbers for the ARB studs?

Changed oil and filters with a quart of Opti-LUBE ZDDP oil fortifier. Trying out NAPA 15w-40 oil I picked up on sale a while back.

The clamping bolt is part 13+14 in the diagram below, where the cable passes through the firewall now is only big enough for the cable, not the proper bolt. I assume I should enlarge the hole to use the proper bolt or it currently routed incorrectly. The second diagram shows the clamping bolt...

Should I drill the current hole so I can use the correct clamping bolt? The current hole is too small.

Greetings I have an issue with my throttle cable moving on its own and the idle slowly rising. I replaced the throttle return spring and cleaned and lubricated the accelerator pedal an associated linkage to no avail. I am not sure my cables are routed properly and want to confirm as I plan to...

Does anyone know the official name of the hollow core cinch bolt? I checked at a local hardware store and Napa and neither had anything close.

I installed a new throttle return spring. Not having the cable cinch bolt may be the issue as the entire cable is moving in and out of the firewall. I checked the following TM and without the cinch bolt cant achieve the spec below....

I’m having a similar idle issue, my throttle needed to be pulled out about an inch to idle normally Since I got the truck 1.5 years ago. The idle cable started moving back in by itself while driving causing low idle when warming up / cooling down or stopping. I replaced the throttle return...

Add a new throttle return spring to the list for this week! I think the old one was tired and not correct.

During the past 2 weeks I’ve worked on sanding and painting my fuel tank mounts and straps as well as sourcing a NOS fuel tank and new in-tank fuel pump. I completed the install today after tapping 5 un-threaded fuel pump mounting holes. The tank also got a NOS fuel sender and a new fuel cap.

Thank for choosing me and thanks to www.shoptrigger.com for the giveaway, it’s appreciated!

So I’m looking at tapping to 10-32NF?

I agree, I checked each hole for threads with a flashlight and toothpic

Greetings! My original fuel tank developed a leak and I was able to purchase a NOS stock M35A2 fuel tank. I was removing the sealer in the moutning holes for the fuel level sender and fuel pump and it appears that only every other hole is threaded for the fuel pump mounting screws. Is this...

Thinking of replacing this old recirculating heater with the Zerostart listed above. Does anyone have details on the old one in m pic?

Please count me in!

Replaced 2 fan belts this morning on my truck, after a nice test drive the low needle on the volt gauge is no longer low. The existing belts were at max adjustment; otherwise, I think a tightening would have got her back in the green.

I’m in Florida, my DEUCE had a tile so registering it want too bad, they just wouldnt let me register it as an antique. Insurance was a bit of a pain, most insurers want the vehicle store in a locked garage or locked storage yard.

Replaced an overly worn passenger seat and greased the throw out Bearing shaft. Also aired up all tires to 50psi.