Search results

ok, so educate me. how are they different?

Bulbs are the same, even when they are bad alternators can still energize. your previous post says they are both already charging. look to the connections. you will find it!!. thanks. mark

I bought an 86 1009 several yrs ago from a drug task force in texas with 3600 miles on it. it was as near new as ive seen down to the floor mat, the 10.00-15 rubber, and the new car smell. i paid 5500 for it . it had all documentation from red river arsenal . i think i sold it on ebay.

If you have 14.6 v at the gen 2 and you have just battery voltage (12.7) at the back battery then you have a bad cable connection at the battery post or the connection on the back of the alternator is loose.

You can also swap the batteries and see if the light problem follows after you get the rear charged. it might help eliminate number 2 alternator.

I can tell how i did it but you will need a replacement shaft. i have a couple of core pumps so i had a used shaft. the shaft i replaced had 300k miles on it(my v1500 civi truck) ,ran good but leaked bad. i took a gamble on the used one i had coming from a low milage military truck. since i had...

If the truck starts and runs, does it rev up? if it boogs when you give it fuel you either have a fuel supply problem or a restriction in the pump. third, check the obvious, air supply? you will find it. thanks. mark

Welcome to the site. has the truck run with the new lift pump installed? it should run with the bleeder open and a stream of fuel almost hitting the inner fender(after bleeding air ). if sounds like you have a fuel pressure problem. i would verify the installation of the lift pump, including the...

Here is the expansion plug install picture, its holding after 30 minutes at operating temp. the hammer handle is holding the gasket down while running. its the old gasket but looks new, someone has been in here before. thanks. mark

Thanks for the info. i repaired the rack by joining the two bad pieces together with a metal strap, and so far its working fine. i have two other parts trucks, one with a tilt wheel but its an 82, dimmer switch is on the floor, and another 1008 thats pretty well picked over. our local...

Hey there , it wasnt me, i thought you were bidding against me! i try to buy only 1028's . someone ran me 300 or so over what i wanted to pay. your truck was the buy of the day, mine was the highest price of the group. mechanically mine will be ok, runs great, i hope to get to drive it tomorrow...

The tiny ones under the intake runners. oreilly's had them, 555004. 29/64 expansion/freeze plug. nobody shows them for the 6.2 except gm, but the parts guy found a bag from dorman for a 350 gas engine with different sizes. these were in there and they look right. we'll find out tomorrow.

Ive got to find another source for the plugs, im out . when im out looking for those ill pick up some of that stuff. the plug i removed was completely hollow, like it was drilled out. thanks. mark

Today i put the two pieces of the rack together with a metal strap. the hardest part of putting it all back together is getting the lock cylinder clocked right so it rotates and starts the way it did before. i lubed everything real good, and its working fine. i got the horn back, and the wheel...

Im just northeast in hutto, im happy to give you some help. thanks. mark

Thanks for the info, im going to try modifying the dorman part, and if that doesnt fix it ill visit my local pick-in-pull . i have another parts truck but it has a tilt wheel, and i could go that route also. thanks. mark

That is really not true. running on dry pavement for an extended period of time will cause premature wear on the drive line. think about what happens when you drive in 4x4 on dry pavement and turn a corner, you can feel the torque lock.(everything binding up) try it going slow and see for your...

What they list is for tilt wheel only, they are different. thanks. mark

Thanks for the info, i was at 3 parts stores today and found nothing, nobody could cross the gm part number, and the number dorman gives is not my number. it looks like it will work, though. thanks When you run the application on dorman's website it says this part will not work. shows 93-94 gm...

This is what is called a rack, wich comes off the key cylinder to push the rod to start your cucv truck. ive been looking for one . the gm part number is 7843368. it has been discontinued. my local dealer gave me a list of the remaining dealers that showed this in inventory. some people may need...