Search results

Prob sorted................on bleeding the brakes the pushrod that goes into the master cylinder popped out of the piston and was sitting crooked.A quick stamp on the brake and someone levering the pushrod on the return into the middle sorted it.Should have noticed it really the same happens...

NO,i never....duh.Will try that.Thanks.

Yesterday i changed both front flexy brake hose and bled them.Now the rear brakes stay on.Before when i switched of the motor something in the air system would release air slowly for a hour.It would make a ticking sound.After changing the pipes on the front this ticking sound had stopped and the...

Replaced front L/H axle seal,replaced both front flex brake pipes,New locking ring front L/H bearing.New J pipe arrived now awaiting 2 gaskets.Replaced tank sender unit.New horn button kit fitted.

Seal arrived in 2 days from Germany and job done in under a hour:D

Yesterday i bought a a2.Drove 200 odd miles home.When i was home the L/H wheel inside was covered in oil.I take it the axle seal is gone.Is this the offending seal???

Not a lot......but i did sneak out and buy a 1957 M35a2:D

Only thing i can say is chief,it took me about 45 mins to do.The most time consuming thing was getting the old bushings out on each end.I just cut the rubber off on one side of each old bushing and pushed then out with a vice and socket.The new ones are the 3 piece bushings from LMC.Didn't even...

New sway bar bushings fitted,front r/h hand bottom fender splash guard,driver's and passenger's outside window rubbers.

Oh,and we pronounce it properly:-D

Mine arrived today Dorman one from rockauto and guess where it's made..............You got it China.

You answered your own question......."English Language".I rest my case.:doh::D

Thanks for the smart arse reply............but over here on my side of the pond we call them bushes.

Anyone know off hand the width of the front sway bar bushes? I know it's a 1 1/4 bar.LMC has 2 differant size bushes hard to measure while the old ones are still fitted plus they are all squashed.

My Gov loc gave up the ghost 4 years ago.I put a same ratio plain jane in mine.Job Jobbed.

Done both of mine.Took about 30 mins for each one.

Yup.a better pic.

Here's mine.

Just fitted my LMC headlight harness.Took a hour to do.Oh and guess where it's made...you got it Taiwan and the rear axle bump stops i ordered.

That cable is ok on mine.Now the **** thing slips in top gear.So the tranny is getting ripped out and rebuilt.