Search results

Sure hope no one POSSOM NAPS that rodent again like what happened at the MVPA convention, WM was a SIGHT to SEE, you could see just by looking at him that he was about to pop because his blood pressure was so HIGH, he was on the war path, in fact he was SO agitated that he could hardly talk (...

yes

Why buy a NEUTERED 6x6 for a high price when you can BUY a REAL MV for a lot less, just because it has been cut up and modded does not mean it is worth more money. Just like a old piece of furniture sells for a fairly cheap price, call it a "antique" and it sells for a higher price.

Bet it has a "jake" brake

Yes, a military off road wrecker is designed for that OFF ROAD recovery, motor pool lifting (pulling power packs, ect.) and at one time for loading missiles on launchers. I am not saying that you can not use a tactical military wrecker or even just the bed in the civi world, just that you will...

EMAILED and phoned everybody on the list last night, guess I need to do this again minus the good list.

The military wreckers USE 1/2" wire rope for the hoist line. You CAN NOT run smaller cable, the drum is a FLUTED drum (not a flat drum but ridges for the wire rope to ride in) these flutes ARE set to support 1/2" w/r under LOAD, if you use a thinner cable, the cable will not be supported so it...

If he makes the drum wider, the load would be the same on the drum drive and brake, the problem he might have will be getting the cable to lay right on a wide drum (the fleet angle might be to tight), if he went to a fatter drum (higher flanges), then the extra wraps WOULD put a lot of extra...

Double the width of the drum, you would need to make NEW drum mounts.

We just used the tensioner on Swiss's m62 and a 3lb hammer (used at the start to get the first two wraps tight against the drum flange) to REwrap the cable on the rear winch, after the first two wraps, the cable spooled on just fine just using the level wind.

ALSO the kink needs to be Unkinked THEN straighten the cable by some reverse bending in order to get the cable to wrap right.

I have a large MAGNET that I will put behind the 819 so FERROs dropped RUST (may be a important part) can be returned to him.

That was my point, but I like PBs idea better, a good DEPRIVE the EMENY DEMO.

Naw, we will either towbar it OR just leave it for the emeny.

That was his JOB, "Nanna Pudden GUARD", see he was just doing his job.

A FRONT blow out is a REAL attention getter, which in my case no one got hurt just the 819 got busted up (air born landings tend to break things)

Operation BS Convoy Ok here is the list so far for OPERATION BS convoy. ANDY3 -- Operation BS Command Convoy position ----------------------------- OWNER 1 -- m1009 ----------- convoy lead--------- Swiss ----- 3/4tcargo trailer 2 -- m38a1 ----------- convoy hitchhiker -- Zout 2 3 --...

That is NO lady.

Well NOW the job WILL be pulling ALL 6 hubs to make sure NO water or mud leaked into the bearings, clean, repacking bearings and putting things back together, this little project might keep you from getting stuck again by making you remember what comes AFTER being stuck in the mud, think you...

Called