Search results

I already looked into it and absolutely doable. Swap out the PSU and run 6 new wires in the harness. I was thinking along the lines if there was interest in a complete plug and play kit to do so.

Anyone interested in a dual circuit ctis system? This means the front and rear tire pressures are able to be programmed independently to have better tire wear and ride quality. Some of the factory black ctis controllers are able to use this system or the newer MRAP controllers with the...

Compared to the auction prices today that is a good price. People are going crazy.

Looks clean on the surface. Really doesnt tell much. Missing the inner fender liners, running a wix oil filter rather than a genuine cat (concerning), Tailgate is tweaked, got repainted kinda bad, hydraulic reservoir is empty, Hydraulics on the winch probably need all resealed, non air ride seat...

When I scanned my ecms most of the time was idle time. Maybe a few hours at full cruising highway speeds. 20k gets your foot in the door. Like I said the small stuff missing can make it easily 30-40k. Sent from my iPhone using Tapatalk

Occasional on highway use unloaded will do just fine. Not a speed demon by any means though. Loaded at 45+ is where the stock NA NHC 250 gets painful.

Hey man welcome from north ga. I absolutely love my a2 truck but unfortunately for site work the a1/0 is the better truck. Every single other use the a2 is better IMO. Basically any highway use get an a2.

Felt the same about my MTVR Ac Kits. Everything was so nice and packaged but boy it was way too hot to not install it.

You are absolutely right on the parts department. I am currently parting out 2 mtvrs at reasonable prices for as many parts as possible to try to alleviate this issue. The build quality on a mtvr is far far far higher than any fmtv i have worked on and even higher than the m939. All grounds are...

I respect the full send. Needed more initial velocity and that concrete block not in the bed and you may have made it out. looks like your rear just sank.

I have everything except the winch controls.

ANOTHER REMINDER!!!! ALWAYS COPY YOUR CONFIGURATION FROM YOUR TRUCK AND SAVE IT IN A SAFE PLACE AND EVEN MANUALLY WRITE DOWN YOUR INJECTOR TRIM CODES!!!!!! I totally forgot and flashed the 505 which 90% of the time resets your configuration and you will have to pull the valve cover at a minimum...

Any cat et later than 2001 should work fine.

2019a works fine no problems for me.

I will have some here in a month or so when I go pick up my parts trucks. Complete cab ext.

I agree so distributing those TM's free of cost would help the hobby tremendously but in fact distribution of them at all is illegal because the a1r tm is not for distribution.

IDK what you mean by interpreting the code at all. You simply connect the adapter to the laptop and open the program you want to diagnose and select j1707 for anything but the engine which is j1939 protocol and the software will tell you the error code then you can diagnose the problem from...

I have an entire software package for free for your truck(wabaco, cat et, allison, dana) PM me your email. Only need a chinese nexiq adapter off ebay and a few hours to screw around installing the software and your off to the races.

As swiss stated before this was my introduction into the MV hobby. I thought the project of converting the truck into a dump truck would be a fantastic learning experience and taking care of the truck entirely on my own teaching me responsibility. Some of the Ideas that Ron had were good on...

Likely fell out of the crate and got banged around for 10 years.