Search results

Also, I taped up my buzzer and covered the opening with tape, then buried it behind the dash. I think I will be able to hear it, but not be annoyed.

I can reach it if I need to, but I don’t see myself adjusting it unless I am really in a dark place and need all of my night sight.

that is right above the gas pedal but tucked back in there.

Well, installed my dimmer switch. I have a slight interference on the new dash switches with some sheet metal. I clear the frame that the dash mounts to, but the sheet metal of the cab behind that ring is interfering. It isa minor trim, just going to take time to pull it back apart and...

Yeah, but I had free access to a plasma table….. so I got what I got. Sent from my iPhone using Tapatalk

They have no slack to be moved elsewhere. Will have to take the time to search the TM’s.

looks awesome as usual!

Got my fording switch wired into my AC harness. I won’t get all of my switches wired for a while, but I wanted to paint my new dash while everything was apart, so I inserted the switches where they go. Next task is to get the truck mobile again. curious thing I found. P912 and J913 were...

Thanks for the feedback. Sent from my iPhone using Tapatalk

I did a search….. but my question was not found by me. Lots of questions below. I need to prime some new steel parts. There is mil scale on it and I cannot sand blast. Do you have advice on prep? I was planning on Scotch pad on a grinder to knock off critical areas of thick scale. Then...

All, I have a couple things I am gluing to a Behr painted truck. I am gluing a flat glass panel using windshield adhesive. I am gluing a fiberglass panel in using Sikaflex 252. I am gluing a patch of steel (sealing a hole in an unweldable location) using 3M Urethane Seam Sealer, 08362...

I thought about removing it, but then I realized that the lower center hole is not really visible. If I cut a new panel ever again, I would skip that hole. For that reason, I am leaving it in the almost useless hole.

On the bench assembled.

Thanks for closing the loop! Sent from my iPhone using Tapatalk

I plan on a tool box kitchen as well. Are you assuming the truck will be level or are you leveling the kitchen some how?

sorry, I meant for your CTIS switches. on another update…. I bought nice new 5mm screws for my light switches…. They must be 10-32 instead. Reveal will wait until I get new bolts……

Did you by chance post the schematic for your setup?

Painted the dash, received my switches. Tomorrow I paint the cab inside. Reveal coming hopefully in a week!

I got a bigger puller and a bearing splitter. Gonna try that next. If that fails, I might try the grinder. Sent from my iPhone using Tapatalk

My switches come in tomorrow! Need to paint my cab Saturday, then the reveal!