Search results

All, I am going to try to paint my center hump with vinyl paint from duplicolor. https://www.duplicolor.com/product/vinyl-and-fabric-coating/ I am using the medium grey paint and if that is too light, I will go darker with top coats. I bought all of the cleaners and adhesion promoters they...

All, I just found this site for cab soundproofing. I am working on my. An right now, and found this site. They have a pretty good selection. I thought I would share. https://www.fehrcab.com/floor-mat-bulk-roll-material-57/ I plan to get some floor mat material for the sides and see how it...

I wish you the best of luck and good health. Hopefully they find something easily curable. Sent from my iPhone using Tapatalk

If you put a straight edge on the door, it. Is not straight….. both in fact have the exact same bow. The bulb seals are brand new, so I hate to replace them yet, but that may be my next option. Sent from my iPhone using Tapatalk

That is the gap at the bottom of the door. The silver part is the floor with KillMat installed in it, the green is my door panel. Sent from my iPhone using Tapatalk

I am soundproofing the cab, so can’t have gaps….. they short circuit my baffles. Sent from my iPhone using Tapatalk

Is it normal to have a gap at the bottom of the door? I put a straight edge and the door is curved. Both doors have the same curve. The doors are adjusted really nice. The close and latch solidly, so I am hesitant to change anything. Sent from my iPhone using Tapatalk

I recognized the photos…. Did not see the signatures….heck of a set of collectibles. I might have to pick your brain some if you don’t mind later. That is an awesome build. 20ft container….. did you cut it down at all? Thanks! Sent from my iPhone using Tapatalk

Well, I could not leave that post alone…. Went out and sprayed the fitting. It is obviously rusty from the angles I have to shoot PB blaster from. I even put a coat of satin black on my rust repair I did last month. I will try again to remove the ether bottle tomorrow. Thanks for the...

I was joking about heat and driving a screw driver through a probably/possibly full bottle. I missed my window to spray tonight. May have to spray tomorrow and try Sunday. Too much to do. Sent from my iPhone using Tapatalk

Thanks everyone for the advice. I plan to try tomorrow before it gets really hot. Sent from my iPhone using Tapatalk

Maybe some heat, then drive a screw driver through the can like a stuck oil filter? [emoji1787] Sent from my iPhone using Tapatalk

I need to remove my ether bottle. My truck is from Hawaii, so my guess is it is completely full. I tried to turn it by hand (I am assuming it is like a propane bottle), but it would not budge. I am a little worried about what will happen if I put my large channel locks on it. I am...

Which orientation is correct? I am guessing pointing up.

Thanks! That helps. I will get supplies on order so I can get this done soon. I plan to do a lot of welding and wanted an easy kill switch. Sent from my iPhone using Tapatalk

Just ordered my switch…. Will be in next week. By any chance, do you know what size wire and lugs you used? I am not near my truck and want to Amazon my parts so it all arrives at the same time. Thanks Again! Sent from my iPhone using Tapatalk

That is exactly what I was looking for. Thanks! Sent from my iPhone using Tapatalk

Go for it Bret. You should spoil yourself every once and a while. Sent from my iPhone using Tapatalk

Did you make it? Sent from my iPhone using Tapatalk

Most composting toilets that go in an RV really only dry out the poop (like cat litter does) and possibly break it into smaller dirt like pieces. The saw dust, coconut husks, pear moss, etc…. Soaks up the water and then a fan sucks the moisture and odors outside. The poop is actually not...