Search results

7409623 is the p/n for stock with 1100x20s, over drive trans does not matter

tire sat flat, side wall gave it up

only need to run long enough for GL to asy "DRIVEN ON TO LOT" :driver:

Would not use heat to expand the end, that much heat is bad for the new insert and the torque rod

WE all can see why that was, that should not have been a surprise,rofl

that gen, rack on the right side looks like the right tank mount, CAN NOT believe this is a GOV. build, no way

a moded m52a2 with a civi van box, the trans is non overdrive, with 5th being direct, may be a 109 box????

Do not know about the deuce torque rods, but according to the 211 TMs (54 series ), so this also would apply to the 809 series and I think the 900 5Ts, you ONLY can REMOVE and INSTALL the insert from ONE SIDE, if done from the WRONG side, the insert will be damaged as well as the torque rod.

use curved jaw vice-grips on the line nut

A Power Control Unit (PCU) is different then a winch, has ONLY ONE direction of pull, different clutch and brake set up, a lot LESS line pull, has a lot thiner cable, also a self contained unit with controls, ect, and a consent turning driveshaft, a lot lighter build, not designed to pull a load...

that looks awful long for a bridge truck, also what nose is on it,

this dozer is not equiped nor heavy enough for that pull scraper

bet with tires and cable rigged from a twin pcu on the back of a old D7, it would work just fine, the hold up would be finding a twin pcu dozer

Was hopping that USA Steel Soldiers were still fighting so thay would have had to fish it out, and need a few more drivers, oh well, I can still hope

check tie rod ball joints,, as well as for BENT tie rod,

M890 >??????????

Heres a link for 1/87 military vehicles www.united-fun.com

"That's ok you got the flat bed I was hunting for" The unit in set1, pic 5, was made in two runs, the first in the early 80s had a semi-gloss OD, the second which is easier to find was from the 90s to not quite present, it had a flater, lighter OD. The 870/931 combo in set 3, pics 6, 7, the...

Another place to look is Walthers .com, thay are a major HO supplier, search military vehicle

Check epay, I found a lot of my 1/87 (HO) there, even some very rare, search 1/87 roco, 1/87 trident